User manual ROSE DISPLAYS ANOSCREEN WITH ANOFOOT

[. . . ] AnoScreenTM Parts Instruction Sheet AnoScreen Corner Bracket 06-3000 AnoFootTM 12-0200 Corner Brackets Vertical Rails with Flex Spine Single rails Split rails Instructions for Assembly Step 1 Insert corner brackets into ends of bottom rails, using thumb, as shown in illustration. [. . . ] Note: Use the two vertical rails without flex spine connectors on the outside edges of the outermost panels. 4 5 Step 5 Insert corner brackets into ends of split rails. Use thumb, as shown in illustration. 7 6 Step 6 Assemble split rails onto top ends of vertical rails, one inside and one outside of each panel of the AnoScreen. Step 7 Insert and change signs through top of each panel. 7 Step 8 Snap AnoScreen corner brackets onto split rail at a 90° angle. Corner brackets & Split Rails AnoScreen Corner Bracket AnoFoot The AnoScreenTM is a registered trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoScreenAnoFoot Incept-8. 15. 02 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com AnoScreenTM Parts Instruction Sheet AnoScreen Corner Bracket 06-3000 AnoFootTM 12-0200 Corner Brackets Vertical Rails with Flex Spine Single rails Split rails Instructions for Assembly Step 1 Insert corner brackets into ends of bottom rails, using thumb, as shown in illustration. DETAIL 1a- Corner bracket tension tab faces toward outside of frame. 1 1a Step 2 Snap one AnoFoot onto both the left and right sides of each bottom Ano rail section. 2 3 2 Panel Step 3 Lay out parts as they will be configured on the floor. (2, 3 or 4 panels) 3 Panel 4 Panel 4 (continued on other side) The AnoScreenTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INAnoScreenAnoFoot Incept-8. 15. 02 AnoScreenTM Instruction Sheet (side 2) Instructions for Assembly continued Step 4 Assemble the vertical rail assemblies onto the upward facing corner brackets already inserted into the bottom rails. [. . . ] Part #02INAnoScreenAnoFoot Incept-8. 15. 02 [. . . ]