User manual ROSE DISPLAYS ANOSKYBOX-TOP LOADING 4 WAY

[. . . ] AnoSkyboxTM Parts Top Load 4-Way Instruction Sheet Page 1 of 2 4 Spines with pre-drilled holes 32 Corner brackets 12 Single rails 9 Split rails Instructions for Assembly Note: We recommended that two people assemble this AnoSkybox. 1a 1b Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. [. . . ] Holes should remain at the top of the AnoSkybox for hanging. Top Load 3-Way Instruction Sheet Page 2 of 2 Instructions for Assembly continued 4 5 6 7 Step 5 Insert corner brackets into ends of split rails, 1 per end. Use thumb as shown in illustration. Step 6 Assemble split rails onto top ends of vertical rails, one inside and one outside of each side of the AnoSkybox. 8 9 Step 7 Insert and change signs through top of each side. Step 8 Assemble hanging hardware by inserting hooks through holes on the spines. Step 9 Hang the completed assembly. Note: Steps 7-9 illustrate a 3-Way AnoSkybox. Assembly is the same for a 4-Way The AnoSkyboxTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INAnoSkyboxTopLoad4Way 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-2. 07. 03 AnoSkyboxTM Parts Top Load 4-Way Instruction Sheet Page 1 of 2 4 Spines with pre-drilled holes 32 Corner brackets 1a 12 Single rails 1b 9 Split rails Instructions for Assembly Note: We recommended that two people assemble this AnoSkybox. Step 1a Slide spine into vertical rail. Step 1b Slide another vertical rail onto the other edge of spine. Repeat for all vertical rails and spines. 2a 2b Step 2 Carefully insert corner brackets into ends of bottom rails, using thumb as shown in illustration. Detail- It is important that the corner bracket tension tab faces toward outside of frame. (2b) 3 2 Step 3 Lay out the bottom rails on the floor as they will be configured. 4-Way (Continued on other side) The AnoSkyboxTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INAnoSkyboxTopLoad4Way Incept-2. 07. 03 AnoSkyboxTM Step 4 Assemble the vertical rail assemblies onto the upward facing corner brackets already inserted into the bottom rails. All four brackets should go into the vertical rails at one time. [. . . ] Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INAnoSkyboxTopLoad4Way Incept-2. 07. 03 [. . . ]