User manual ROSE DISPLAYS SUPERSNAP WITH CABLE CLIP AND BALL CHAIN

[. . . ] 3 Figure 1 Figure 2 Step 3 Align one round end of cable clip with top channel of the rail and insert. Once in place, insert end of ball chain into channel. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. [. . . ] Once in place, insert end of ball chain into channel. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Note: Be sure to push on the cable clip in order to slide the ball chain into place. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 Figure 4 Step 4 Push end caps into place. Finished Look Important note: Please save and reuse the SuperSnap, End Caps and Cable Clips for future projects. Figure 5 Finished Look The SuperSnapTM is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #02INSSuperSnapCCBC 35 Congress Street, Salem, MA 01970 Tel# 1- 800 631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com Incept-11. 13. 02 SuperSnapTM Instruction Sheet Parts SuperSnap 12S300 Cable Clips 06-5050 Ball Chains 96-0302P End Caps 06-5475 Instructions for assembly Step 1 Snap the SuperSnap open and insert poster (top and bottom). 1 Note: It is easier to open and close the SuperSnap by starting at one end and working your way down the holder. 2 Step 2 Insert single ball of ball chain into inner channel of Cable Clip. 3 Figure 1 Figure 2 Step 3 Align one round end of cable clip with top channel of the rail and insert. Once in place, insert end of ball chain into channel. Then press down on the other round end of the cable clip and slide into rail by pushing on the clip. 4 Repeat steps 2 & 3 for second cable clip. Note: Be sure to push on the cable clip in order to slide the ball chain into place. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 Figure 4 Step 4 Push end caps into place. Finished Look Figure 5 Important note: Please save and reuse the SuperSnap, End Caps and Cable Clips for future projects. The SuperSnapTM is a trademark of Rose Displays, Ltd. [. . . ] 4 Note: Be sure to push on the cable clip in order to slide the ball chain into place. Do not pull on, or push against, the ball chain as this will cause it to bind in the channel. Figure 3 Figure 4 Step 4 Push end caps into place. Finished Look Important note: Please save and reuse the SuperSnap, End Caps and Cable Clips for future projects. Figure 5 Finished Look The SuperSnapTM is a trademark of Rose Displays, Ltd. [. . . ]