User manual ROSIERES DVI 2 1 PN

[. . . ] The manufacturer accepts no liability for this service. Any action that the manufacturer has to take due to an erroneous installation will not be covered by the guarantee. The flush-mounted cook tops are designed for installation in work tops made of all kinds of material, providing they can withstand a temperature of 100°C, and are between 25 and 40 mm thick. If the cook top is installed in a position so that the side of a kitchen unit comes up against its left-hand or right-hand side, the distance between the vertical panel and the edge of the cook top must always be at least 150 mm. [. . . ] This indication only disappears when there is no longer any danger (at 60°C). To save energy, turn off the burner in advance, in order to exploit the residual heat. The residual heat indicator “H” is lost in the event of a mains power cut lasting more than 3 seconds. Turning off the cook top (Fig 10) The cook top can be turned off at any time by means of the on/off key (1). The display shows a “H” as long as the temperature remains above 60°C. Safety cut-out 15 If one or more burners are accidentally left on, the control automatically turns them off after a certain time has elapsed. The table below indicates the time interval, which depends on the power level setting. level 1 2 3–4 5–6 7–8 9 P Time limit (hours) 10 5 4 3 2 1 10 min. If the safety cut-out has tripped, the symbol “H” is displayed. To avoid the automatic cut-out being tripped, simply touch the burner selection key or the “+” or “-“ keys before the time runs out. Booster functions( Fig 11) The “booster” function for the ∅210 mm burner is enabled by touching the “Booster” key (8) regardless of the selected power level. When this function is enabled, the display shows the letter P. If the power delivered to the other ∅ 145 mm burner exceeds 600W, this is automatically reduced to 600W. The corresponding indicator begins to display the new lower power setting and the previous power setting alternately. System temperature control A temperature sensor situated inside the cook top’s cooling unit constantly measures the temperature of the generator’s electronic circuits. In the event of these circuits overheating, the system reacts as follows: The display related to the induction plates shows the power levels alternatively with the symbol “c”. The overheating of the circuits definitely indicates an anomaly and means that the cook top has not been installed properly, or the openings for air circulation are not large enough 9. Pan sensor Each burner is complete with its own sensor for detecting the presence of a pan. The system is fine-adjusted to recognize the presence of a pan that, according to the scale of the EN standards, is one size smaller than the nominal diameter of the burner. If no pan are detected or if an aluminium pan is detected, the power level flashes on the heater display. After 30 seconds the power levels returns to 0. If the power level symbol flashs also when a pan is actually on the burner, this generally means that the size or shape of the pan concerned is unsuitable. [. . . ] Any spillages from the pans should be wiped away immediately. Important notes Warning: the burner surface becomes red hot when in use, so it is always advisable to keep children well away from the cook top. Avoid dropping any hard object on the cook top surface. In some conditions, the material is sensitive to mechanical loading. [. . . ]