User manual ROSIERES F 122

[. . . ] - If the cable is damaged, replace it as soon as possible with another one which has the same characteristics and which is suitable for use at the power level of the appliance. This procedure must be performed by a qualified technician. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. [. . . ] If a connection tube composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the cooker hood exhaust to the same conductor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source. Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig. 8) so that the unit is easier to handle. We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier. Fix the appliance to the wall and align it in horizontal position to the wall units. When the appliance has been adjusted, definitely fix the hood using the screws A (Fig. For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. FIXING THE DECORATIVE TELESCOPIC FLUE EXTRACTOR VERSION Arrange the electrical power supply within the dimensions of the decorative flue. When this time has passed the motor switches off and the fixed letter "C" must be visualised on the display until the motor re-starts after 50 minutes for another 10 minutes and so on. Press any key apart from the light keys to return to normal functioning. Active carbon/grease filter saturation: - When display item C flashes, at a speed where it alternates with the letter F (e. - When display item C flashes, at a speed where it alternates with the letter A (e. After the clean filter has been positioned correctly, the electronic memory must be reset by pressing button A for approximately 5 seconds, until the indication F or A shown on the display C stops flashing. 11) LUMINOUS the key symbols are explained below: A = LIGHT B = OFF C = SPEED I We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). - To prevent potential fire hazards, the anti-grease filters should be washed a minimum of every 2 months (it is possible to use the dishwasher for this task). - After a few washes, the colour of the filters may change. This does not mean they have to be replaced. [. . . ] By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. Active carbon/grease filter saturation: - When button A flashes at a frequency of 2 seconds, the grease filters must be cleaned. - When button A flashes at a frequency of 0. [. . . ]