User manual ROSIERES F 144

[. . . ] Fix the bracket to the ceiling using the screws and screw anchors provided (Fig. Be careful, because the position of the bracket determines the final position of the apparatus: the side with the slot B corresponds to the side opposite the controls. Ducting version: Fix the telescopic structure to the bracket by means of 4 screws (provided), running the air evacuation pipe through the telescopic structure and the electric power cable through the special hole in the bracket (Fig. 6), taking into account that the height of the hood is 45 mm and that the distance between the hood and the hob must be at least 650 mm (Fig. [. . . ] Take the upper flue (with the round slots) and fit it on the telescopic structure with the slots facing upwards; fit the flue to the bracket with 2 screws (Fig. Take the lower flue and fit it in the same manner as before; slide it to the top and stop it in that position using a adhesive tape (Fig. Take the flange with the metal valve (Fig. 10H) and assemble it onto the opening of the hood for air venting, pressing slightly. Fit the hood to the telescopic structure by means of 4 screws (provided) ­ Fig. Make the electrical connection by means of the power cable. Remove the adhesive tape and pull the lower flue downwards, placing it gently onto the apparatus. Filtering version: Fix the telescopic structure to the bracket by means of 4 screws (provided), running the electric power cable through the special hole in the bracket (Fig. 6), taking into account that the height of the hood is 45 mm and that the distance between the hood and the hob must be at least 650 mm (Fig. 13), fit the flange (G) to the baffle (F) locking it with a turning movement. To deactivate the Air Refresh function, press the button P3 until the icon D7 goes off. The function Air Refresh activates only if the motor is not working. Starting the function Air Refresh, the hood recycles the air in the environment in perfect silence, starting every 5 minutes (for 10 minutes, at the first speed). NOTE: The Sensor and Air Refresh functions can be activated simultaneously by pressing the button P3 until both the icons (D4 and D7) come on. The icon switches on when the engine is at the first, second or third speed. To the fourth speed, the icon switches off and the icon starts working to the maximum speed (icon D3). icon D10: CHARCOAL FILTERS ( For the hood in the filtering version). It switches on when it is time to replace the charcoal filter/s (after about 120 working hours). One time the charcoal filter/ s is replaced, to make the hours calculation start again press the button P4. Sensor sensitivity: the sensor sensitivity can be modified by simultaneously pressing the buttons P3 and P4 (the value set appears on the display D5 and may be between 1 and 9). [. . . ] One time the charcoal filter/ s is replaced, to make the hours calculation start again press the button P4. Sensor sensitivity: the sensor sensitivity can be modified by simultaneously pressing the buttons P3 and P4 (the value set appears on the display D5 and may be between 1 and 9). Warning: in order to avoid damaging the sensor, never use silicone products near the hood!Grease filters: the grease filter/s require particular care and must periodically be cleaned in relation to use. [. . . ]