User manual ROSIERES RDVE342

[. . . ] This manual constitutes an integral part of the appliance. It must be kept intact and within easy reach during the entire life of the cooktop. Please carefully read this manual and all the instructions contained herein before using the appliance. Keep any spare parts supplied with the appliance. [. . . ] This operational procedure must take place within 10sec and no other key than the one described above may be pressed. The electronics remains in a locked condition until its released, even if the control until is switched off and on again in the meantime. For release, press the cooking zone select and the minus key simultaneously. €L“ for LOCKED disappears from the display and all cooking zones display “0“ with a flashing dot. After switching off the control unit the child lock is reactivated. To de-active the lock function definitely, press the cooking zone select key and the minus key simultaneously followed by pressing only the minus key again. After carrying out all steps in the correct order and within a period of 10 sec, the locking is cancelled and the control unit is in a STAND-BY mode. If the control unit is switched on again by pressing the ON/OFF key, all displays show "0", the display dots keep flashing and the control unit may be operated for cooking. Use of the multiple circuits (where supplied) Depending on the model, your appliance can have a DUAL or a TRIPLE heating element. When a multiple plate is activated, the internal circuits are turned on. If you also want to turn on the outermost circuit, you need only select the extended zone key. By means of the multiple-circuit key, the outermost circuits of the cooking zone can be de-activated at any time. an active external circuit is shown by a special additional LED. A new activation of the multiple-circuit key activates the external circuits again and the assigned LED’s come back on. If the element to be controlled is a triple-circuit radiant hotplate, the following applies: Pressing the multiple-circuit button for the first time switches off the outermost circuit and the indicator light at the top of the display. Pressing the multiple-circuit button a second time switches off the median circuit and the indicator light at the bottom of the display. Pressing this button a third time, switches on the median circuit again. Therefore no disturbances with other electronic devices should occur. User with pace maker or other electronic implant are recommended to check with the manufacturer of the electronic device or their medicine if their electronic device is adequate safe respecting to EMC The cooking surface may get hot even in case of inductive heating without direct heating of the cooking surface. But the surface is heated by the pot standing on the cooking zone which reheats the surface. The temperature protection for pots and depends on the planarity of the vessel. iNDUCTION Warnings: The Induction complies with the valid EMC standards. [. . . ] Maintenance - Do not cook with empty neither enamelled or aluminium pans. Use only stainless steel pots and pans with a flat bottom, having same or slightly larger diameter than the heating area (see Fig. Receptacles should not have rough bottoms in order to avoid scratches on the heating glass surface. If you see a crack on the hob, disconnect immediately the electric power supply and contact the assistance Never place hot pans, frying pans, hard or sharped objects on the control panel, knobs area or the frame For cleaning, use only warm water with a mild detergent. [. . . ]