User manual ROSIERES RGM 9185 IN

[. . . ] Provide adequate ventilation in the environment for a safe operation of the cooker hood. Follow the local laws applicable for external air evacuation. Before connecting the model to the electricity network: - Control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. [. . . ] For the various installations use screws and screw anchors suited to the type of wall (e. If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed. • Fixing the decorative telescopic flue - extractor version warning!Before fixing the appliance in place, take the lower connector and use a pair of pliers to bend the tab inwards, as shown in figure 5, stage 1. Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance must be installed as an extractor version, make sure an air exhaust hole has been prepared. Adjust the width of the support bracket of the upper flue (Fig. Then fix it to the ceiling using the screws A (Fig. 3) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig. Connect the flange C to the air exhaust hole using a connection pipe (Fig. Insert the upper flue into the lower flue. Fix the lower flue to the hood using the screws B provided (Fig. 5 - Stage 2), extract the upper flue up to the bracket and fix it with the screws B (Fig. Remove the charcoal filters already fitted to the appliance by turning them 90° anticlockwise (Fig. € Filtering version Install the hood and the two flues as described in the paragraph for installation of the hood in ducting version. The charcoal filters are already fitted to the appliance. Quency with which the appliance is used, the type of cooking performed and the regularity with which the anti-grease filters are cleaned. € Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral, non-abrasive liquid detergents. € The light on the cooker hood is designed for use during cooking and not for general room illumination. Extended use of the light reduces the average duration of the bulb. To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks. Replace the bulbs with new ones of the same type. [. . . ] The filters are not washable or re-usable and must be replaced at least once every four months. The active carbon filter saturation level depends on the fre- - 18 - - check that the plug has been inserted into the power socket correctly. If you cannot identify the cause of the operating anomaly: switch off the appliance (do not subject it to rough treatment) and contact the Assistance Service. It is important that you inform the Assistance Service of your product code and its serial number (a 16-character code which begins with the number 3); this can be found on the guarantee certificate or on the data plate located inside the appliance. [. . . ]