User manual ROSIERES RGV64FM PN

[. . . ] Da 25 a 45 mm Min 10 mm B SAFETY INSTURUCTIONS • WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. € Children under 8 Year of age must be kept away from the appliance unless they are continuously supervised. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. [. . . ] Use only pipes, washers and sealing washers which comply with the relevant national standards. For some models a conic link is furnished to outfit for the installation in the countries where this type of link is obligatory; in picture 8 it is pointed out how to recognize the different types of links (CY = cylindrical, CO = conic). In every case the cylindrical part of the link has to be connected to the hob. When connecting the hob to the gas supply via use offlexible hoses please ensure that the maximum distance covered by the hose does not exceed 2 metres. 06 GB The flexible tube shall be fitted in such a way that it cannot come into contact with a moveable part of the housing unit (e. A drawer) and does not pass through any space where it may become crushed/ kinked or damaged in any way. To prevent any potential damage to the hob please carry out the installation following this sequence (picture 6): 1)As illustrated, assemble parts in sequence: A: 1/2 Male Adaptor Cylindirical B: 1/2 Seal C: 1/2 Female Gas Adaptor Conical-Cylindirical or Cylindirical-Cylindirical 2)Tighten the joints with the spanner, remembering to twist the pipes into position. 3)Attach fitting C to mains gas supply using rigid copper pipe or flexible steel pipe. IMPORTANT: carry out a final check for leaks on the pipe connections using a soapy solution. Also, make sure that the flexible pipe cannot come into contact with a moving part of the cabinet (eg. Adrawer) and that it is not situated where it could be damaged. Warning: If gas can be smelt in the vicinity of this appliance turn off the gas supply to the appliance and call the engineer directly. Do not search for a leak with a naked flame. For models fitted with a safety tap (which cuts-off the flow of gas if the flame is accidentally extinguished) the burners are ignited and described above, but care must be taken. Prior to switching on the gas hob ensure that the burners and burner caps are correctly placed within their position. GENERAL ADVISE For best results, use cooking vessels with a flat surface. The size of the surface should match the gas burner side as follows. ADAPTING THE HOB TO DIFFERENT TYPES OF GAS To adapt the Hob for use with different types of gas, carry out the following instructions: •remove the grids and burners •insert on hexagonal spanner (7 mm) into the burner support (Figure 7) •Unscrew the injector and replace it with one suitable for the gas to be used (see gas type table) For smaller containers the gas burner should be regulated so that the flame does not overlap the base of the pan. Vessels with a concave or convex base should not be used. The special removable support, supplied with some models, must be used only on the auxiliary burner. WARNING: If a flame is accidentally extinguished, turn the knob to the off position and do not attempt to re-ignite if for at least 1 minute. If over the years the gas taps become stiff to turn it is necessary to lubricate them. [. . . ] Declaration of compliance: This equipment, in the parts intended to come into contact with food, complies with the regulations laid down in EEC directives 89/109. This equipment, in the parts intended to come into contact with food, complies with the regulations laid down in EEC directives 89/109. The appliance complies with European Directives 2009/142/EC and subsequent amendments. By placing the mark on this product, we are confirming compliance to all relevant European safety, health and environmental requirements which are applicable in legislation for this product. [. . . ]