User manual ROSIERES RLG202IN

[. . . ] The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ] Use soap and water or special liquids to make sure that there are no gas leaks. The use of a rubber flexible hose fastened with hose clamps is prohibited because it cannot be inspected. Other types of gas can be used by changing the burner setting as follows: 1) Make sure that the oven is not connected to the electrical mains. 3) Extract the bottom of the oven after having removed the retaining screws (fig. Reassemble the burner and the bottom of the oven, following the above steps in the reverse order. To adjust the flame, proceed as follows: loosen the screw C and turn the ring nut D to position for natural or methane gas, and position for cylinder gas, aligning the movable pointer on the ring nut with the fixed pointer on the burner. The oven thermostat is equipped with a by-pass for the minimum; when changing the type of gas it is also necessary to adjust the setting in the following manner: Remove the thermostat knob; If the front panel is in glass, remove it by unscrewing the two locking ring nuts located under the other two knobs (fig. 7a); If the control panel is in metal, the adjustment can be made through the opening located on the left side of the thermostat knob housing (fig. 7b); Turn on the oven and let it operate at maximum with the door closed for at least 30 minutes; Move the oven thermostat knob to the minimum and set the by-pass to the minimum so as to obtain a reduced but stabilized flame. Perform this operation with the oven door closed; Use a screwdriver to operate on the notch of the by-pass screw. A few turns of the by-pass screw is sufficient to adjust the minimum when passing from liquid gas to methane gas; After having adjusted the burner, open and close the oven door to check that the flame remains lit at the minimum. if the flame goes out , adjust the by-pass setting. For operation with G30/G31, the adjustment screw of the by-pass must be screwed in completely. When these operations are finished (injector replacement, air adjustment and minimum setting), turn off the oven and replace the data plate with the new data plate indicating the operating gas. Use: the oven burner has a safety valve which block the gas flow in the following cases: - If the thermostat knob is accidentally turned with immediate gas flow. The green light turns on when the selector knob is in any position different from 0. The yellow light turns on when the electric grill is on. It allows to choose between the different cooking functions. It is recommended to keep the oven door open and to use the knob protection. If the thermostat knob is turned accidentally during electric grill operation, a safety device will stop the grill. To restart, rotate the knob until the mark on the knob is aligned with the mark on the control panel. By turning the knob anticlockwise the temperature can be selected between 150°C and Max. [. . . ] Check the successful lighting of the burner through the slots located in the front part of the oven plate; if it is not lit, repeat the operation. The proper operation of the burner should be checked with the oven door closed. Keeping the door closed, check that the cooling fan is operating properly. if the fan does not work , proceed as follows: 1. [. . . ]