User manual ROTEL RCC-945

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. This Class B digital apparatus complies with Canadian ICES-003. [. . . ] Pressing the Disc Skip button when a disc is not playing selects the next disc. If the Disc Skip button is pressed when a disc is playing, the RCC-945 stops playing the current disc, selects the next disc, and begins playing track 1 of that disc. 7 and ] Loading Discs Press the Open/Close button on either the front panel or the remote control to open the Disc Tray. Place discs in the numbered recesses in the Disc Carousel with the label sides up. Be sure the discs are centered in the recesses in the Disc Carousel. Both standard 12cm discs and 8cm discs may be loaded. There is a separate recessed area in the carousel for 8cm discs. When the Disc Tray is open discs can be loaded into the three disc positions at the front of the tray. To load discs into the remaining positions press the Disc Skip button 7] to rotate the carousel. Press the Open/Close button again to close the Disc Tray when you are done loading discs. NOTE: Do not push the Disc Tray in manually. Do not touch the Disc Carousel while it is turning or attempt to turn it by hand, as this also could cause damage. The Intro Scan Indicator G is lit when the Intro Scan feature is activated. One of the Total/Each/Remain Time Indicators J will light indicating what is shown in the Time Display. The Time Display K shows either the total playing time of the disc that is selected, the amount of time the current track has been playing, the remaining playing time of the current track, or the remaining time of the disc that is playing. See the Time Button section. Track Selection Buttons (remote only) d To select a specific track on a disc, press the corresponding Track Selection buttons. The selected track immediately begins playing. To select tracks higher than number 9 simply press the appropriate buttons in quick succession. For example, to select track 17, press the "1" button then the "7" button. NOTE: When the RCC-945 is in Programmed Play mode, the Track Selection buttons are used to select tracks to be added to the program. See the Programmed Disc Play section. The RCC-945 can play discs recorded with the MP3 (Mpeg1, Layer3) format. The maximum allowable number of folders on the disc is 255. The maximum allowable number of files on the disc is 999, with a maximum of 255 in any folder. [. . . ] When the Repeat function is turned on the first programmed track begins playing after the last programmed track has been played. Similarly, the first programmed track begins playing if you press the when the last programmed track is playing or if you press the until you reach the end of the last programmed track. } ] Adding Tracks to a Program You can add track selections to the programmed list when disc played is stopped. If the track you want to add is on the disc that is selected, just select the new track with the Track Selection buttons. Or use the Disc Selection buttons and the Track Selection buttons to add new tracks from another disc to the program. 13 English Troubleshooting Most difficulties in audio systems are the result of incorrect connections, or improper control settings. [. . . ]