User manual ROTEL RCC-955

[. . . ] RCC-955 CD MULTI-DISC CHANGER CD MULTIDISC CHANGER RCC-955 POWER 1 2 3 4 5 PROGRAM RANDOM DISC TRACK REPEAT ALL 1 DISC REMAIN MIN SEC 1234 5678 9 10 11 12 13 14 15 16 OPN/CLS PLAY STOP PAUSE TRACK DISC Owner's Manual CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electrical shock, do not expose the unit to moisture or water. [. . . ] Press the Pause Button again, or the Play Button, to resume playing the disc at the same track and time. Display Panel The Disc Indicators have discs in them. The Play Indicator Stop Button 8 24 Press the Stop Button to stop playing the disc. The disc will remain selected but the track selection will go back to track 1. Track Skip Buttons 10 18 When a disc is not playing: button to select the next track on the disc. Press · Press the button to advance more than one track on the and hold the disc. · Press the button to select the previous track on the disc. button to go back more than one track Press and hold the on the disc. When a disc is playing: · Press the button to skip the rest of track being played and begin playing at the beginning of the next track on the disc. button to advance more than one track Press and hold the on the disc. · Press the button to return to the beginning of the track bebutton to go back more than ing played. Press and hold the one track on the disc. Track Selection Buttons 26 (remote only) To select a specific track on a disc, press the corresponding Track Selection buttons. The selected track immediately begins playing. To select tracks higher than number 10 use the ">10" button. For example, to select track 17, press the ">10" button then the "7" button. Note: When the RCC-955 is in Programmed Play mode, the Track Selection buttons are used to select tracks to be added to the program. See the Programmed Disc Play section. Search Buttons 21 (remote only) Press and hold the or buttons to quickly search a disc in the forward or reverse direction. For the first five seconds the search speed will be approximately four times normal playing speed. After three seconds the search speed will increase to approximately 20 times normal playing speed. The sound volume is reduced while the search function is being used. The search function may be used when disc play has been temporarily stopped with the Pause function, however no sound is heard. The Search function will not go past the beginning or end of the selected disc. 4 shows the positions in the Disc Tray that is lit whenever a disc is playing. The Pause Indicator is lit when disc play has been temporarily stopped with the Pause button. The Disc Selection Indicator typically shows the number of the disc currently selected. If the Remaining Disc Playing Time display option has been selected the Disc Selection Indicator changes to a "­". [. . . ] Or use the Disc Selection buttons and the Track Selection buttons to program new tracks to add tracks from another disc to the program. 12 English Troubleshooting Most difficulties in audio systems are the result of incorrect connections, or improper control settings. If you encounter problems, isolate the area of the difficulty, check the control settings, determine the cause of the fault and make the necessary changes. If you experience problems with the RCC-955, refer to the suggestions for the following conditions: Sound Skips If the sound from the RCC-955 skips or jumps around, the disc may be defective or dirty. If a problem persists it could be caused by vibrations reaching the RCC-955. [. . . ]