User manual ROTEL RCD-06 SE

[. . . ] WARNING: There are no user serviceable parts inside. refer all servicing to qualified service personnel. WARNING: To reduce the risk of fire or electric shock, do not exposetheunittomoistureorwater. donotexposetheunitto dripping or splashing. [. . . ] This manual shows illustrations of the front and rear panels and the RRD95 remote control. Each item in the illustrations is identified with a call out in a gray box. Through out this manual the items refered to in the text are identified by the corresponding call out. The items on the front and rear panels are identified with a number call out, such a 1. The items on the remote control are labeled with a letter call out, such as A. [See Figure 3 for wiring illustration] A pair of standard RCA jacks supplies an analog output signal from the RCD-06 SE to the source inputs of an audio preamplifier, integrated amplifier, or receiver. select high quality audio interconnect cables. Connect the left channel output of the RCD-06 SE to the left channel source input on the preamplifier or other component. Your RCD-06 SE is configured at the factory for the proper AC voltage in the country where you purchased it (either 120 volts or 230 volts). The AC line configuration is noted on a decal on the back panel. Note: Should you move your CD player to another country, it may be Possible to reconfigure it for use on a different line voltage. Do not attempt to perform this conversion yourself. Opening the enclosure of the RCD-06 SE exposes you to dangerous voltages. Consult a qualified service person or the Rotel factory service department for information. [See Figure 4 for wiring illustration] If you are using an outboard D/A converter or other digital processor, you will need an unprocessed digital data stream from the RCD-06 SE, taken before the built-in D/A converter. The RCD-06 SE can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Specific instructions for each of these controls are detailed below. Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. These exceptions are noted in the instructions. This button stops a disc that is playing and resets the player, i. If play is resumed, the disc will start over from the first track. [. . . ] 5 mm mini-jack (labeled EXT REM IN) receives command codes from an industry-standard infrared receiver (Xantech, etc. This feature is useful when the unit is installed in a cabine and the front-panel sensor is blocked. Consul your authorized Rotel dealer for information on external receivers and the proper wiring o a jack to fit the mini-jack receptacle. The RCD-06 SE can be activated by a 12 volt trigger signal from a Rotel preamplifier. [. . . ]