User manual ROTEL RCD-940BX

[. . . ] If the unit is exposed to moisture, or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take the unit to a qualified service person for inspection and necessary repairs. Read all the instructions before connecting or operating the component. Keep this manual so you can refer to these safety instructions. [. . . ] Note: To prevent loud noises that could damage your speakers, turn off all the system components when you make any signal connections. 5mm mini-jack receives command codes from industry-standard infrared receivers (Xantech, etc. This feature could prove useful when the unit is installed in a cabinet and the front-panel sensor is blocked. Consult your authorized Rotel dealer for information on these external repeaters and the proper wiring of a jack to fit the mini-jack receptacle. The RCD-940BX can be operated using its front panel buttons or from corresponding buttons on the supplied infrared remote control. Specific instructions for each of these controls are detailed below. Most of the buttons are duplicated on the front panel and on the IR remote control. However, there are a few exceptions where the buttons are only available on one or the other. These exceptions are noted in the instructions. [See Figure 3 for wiring illustration] A pair of standard RCA jacks supplies an analog output signal from the RCD-940BX to the source inputs of an audio preamplifier, in-tegrated amplifier, or receiver. select high quality audio interconnect cables. the PAUSE indicator will light in the Display. To resume playing the disc, press the PAUSE button again or press the PLAY button. Except where noted, all functions are available on the RCD-940BX front panel and the IR remote control. These buttons are used to select tracks on the disc. When a disc is playing, pressing the right TRACK button advances to the beginning of the next track. Pressing the left TRACK but-ton returns to the beginning of the current track. Pressing twice quickly in succession returns to the beginning of the previous track. The new track number appears in the Display. These buttons are also used to select a track before pressing the PLAY button or when memorizing tracks for the PROGRAM play mode (see below). These selections are made by continuously pressing the TRACK buttons until the desired track is reached. There is also a four by four matrix of track numbers (1 ­ 16) located at the right side of the display. [. . . ] the REPEAT button steps sequentially through the available options. Press the button once and the RCD-940BX will repeat just the current track, displaying the indicators REPEAT 1 in the Display. Press the button a second time and the RCD-940BX will repeat the entire disc, displaying REPEAT ALL in the Display. press the button a third time to cancel the REPEAT function. [. . . ]