User manual ROTEL RT-940AX

[. . . ] Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. Ventilation To ensure good ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). [. . . ] The manufacturer declines any liability should these safety measures not be observed. 60 voltage: 230V/400V~ 3N 50/60Hz maximum power absorbed 8900W Directive 2002/40/EC on the label of electric ovens. standard EN 50304 Energy consumption Class certification Natural convection heating mode: Convection mode. This appliance conforms to the following European Economic Community directives: 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments. 16 Description of the appliance Overall view GB Control panel GUIDES for the sliding racks position 5 position 4 position 3 position 2 position 1 GRILL rack DRIPPING PAN Control panel EXTENDABLE HOTPLATES knob SELECTOR Knob HOTPLATES indicator light HOTPLATES knob THERMOSTAT indicator light 17 Start-up and use GB !The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Cooling ventilation In order to cool down the external temperature of the oven, some models are fitted with a cooling fan that blows out air between the control panel and the oven door. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. Oven light When selecting with the SELECTOR knob the oven light goes on. Practical advice on using the glass ceramic hob !The glue that is applied on the gaskets leaves some traces of grease on the glass. Before using the appliance, we recommend you eliminate these with a special non-abrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. To obtain the best results with your hob: • Use flat-bottomed pans to ensure that they adhere to the cooking zone perfectly. Extendable cooking zones The extendable radiant elements (B) are recognisable by the fact that they have a double heating zone. You can turn on only the smaller internal cooking zone or both the external and internal zones. The control knob allows you to choose between two power levels, which are both adjustable between a minimum value of 1 to a maximum of 9: • the lowest power level can be set by turning the knob clockwise from 1 to 9. • Turn the knob completely (A), until you hear a slight click to enable the maximum power level, which in turn can be adjusted between 9 and 1 by turning the knob anticlockwise. To restore the minimum power level, turn the knob and set it back to position 0. For double cooking zones, the first part of the knob movement activates the smaller cooking zone (internal). [. . . ] If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre. • Remember that the temperature of the cooking zones remains relatively high for at least thirty minutes after they have been switched off. • Keep any object that could melt, away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Keep plastic or aluminium objects away from the hob: if you forget them on surfaces that are still hot, they may cause serious damage to the hob. [. . . ]