User manual ROWENTA DG 530 MASTER

[. . . ] PREPARING YOUR STEAM GENERATOR Fill the boiler : 1. Place your steam generator on a stable, horizontal heat-resistant surface. Ensure that your appliance is disconnected and cold. Using a water jug, fill with one litre of tap water. [. . . ] As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows : · The wire that is coloured GREEN & YELLOW must be connected to the terminal in the plug which is marked with the letter E, or the earth symbol , or coloured GREEN or GREEN & YELLOW. · The wire that is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. · The wire that is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. · This appliance requires a 13 amp fuse. · Should the fuse need to be replaced an ASTA marked fuse, approved to BS 1362, of the same rating must be used. · Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a replacement is obtained ­ make certain that only the correct fuse cover is used and fitted. · For plugs with a detachable fuse cover, the replacement must be the same as the colour insert in the base of the plug, or as directed by the embossed working on the base of the plug. · If the detachable fuse cover is lost, a replacement may be purchased from a Rowenta Service Centre (see enclosed Service Information leaflet). E L N 8. FILLING THE BOILER WHILE IN USE (when the boiler is empty) VERY IMPORTANT : Before opening your boiler, ensure that there is no more steam left inside by pressing the steam control button located under the handle of the iron and keep it pressed until there is no more steam (8). Never unscrew the boiler cap while the iron is producing steam. Press the On/Off switch located on the control panel to stop the steam generator. DG 520 and DG 530 only : press both On/Off switches located on the control panel. Disconnect the steam generator from the mains. Using a water jug, fill with one litre of tap water. Fill the boiler, taking care that the water does not spill over. If this occurs, remove the excess water. Replace the boiler cap, screwing on tightly, reconnect your steam generator to the mains and switch it on. Follow procedure of chapter 3 to continue ironing. GUARANTEE (U. K. ONLY) Details of the Rowenta guarantee are shown on the guarantee card enclosed with the appliance. This guarantee does not affect your statutory rights. Should service or further information be required please contact the Rowenta Customer Relations Department (see Helpline or enclosed Service Information leaflet). [. . . ] · Steam escapes from the boiler cap. · The seal on the cap is damaged. SOLUTIONS · Do not fill the boiler right up to the top. · Contact an Approved Service Centre. [. . . ]