User manual ROWENTA DG 910 EXPERT

[. . . ] Place your steam generator on a stable, horizontal heat-resistant surface. Remove the water tank by pulling the handles upwards (1). Fill the water tank taking care not to exceed the maximum level (2). Replace it fully in its housing (3). 2. [. . . ] Do not place the iron on rough surfaces. Do not scratch or scrape the sole plate. Never use abrasive cleaning agents to clean the sole plate. The base unit : Clean the plastic parts occasionally with a soft cloth. 12. SAFETY INSTRUCTIONS · Your steam generator is an electrical appliance : It should be used under normal conditions. · Your generator is fitted with 2 safety systems : - a pressure release valve which, in the event of malfunction, releases any excess steam ; - a thermal fuse for preventing any overheating. · Connect your iron only to alternating current of the voltage specified on the rating plate and only to a socket with an earthed connection. · This iron complies with EEC Regulations 73/23/EEC and 89/336/EEC. · Completely remove the power cord from its storage space before connecting to an earthed socket. · Always plug your steam generator into : - An electrical installation with a voltage between 220 V and 240 V. Connecting to the wrong voltage may cause irreparable damage to the appliance and will invalidate your guarantee. If you are using a mains extension lead, ensure that it is correctly rated (10 A) with an earth, and is fully extended. · Should the power cord mechanism or the boiler cord linking the iron to the base unit become damaged, it must be replaced by a ROWENTA Approved Service Centre to avoid the risk of danger or injury. Be careful : · The sole plate and generator iron-rest can become very hot and cause burns : never touch these parts. · Your appliance gives off steam which can cause burns. · Handle your iron carefully, particularly when using the vertical function. · Do not direct steam at people or animals. · Take care to ensure that you do not come into contact with electrical cords with the hot iron sole plate. · Always keep the steam generator away from children. · Never leave the appliance unattended : - when it is connected ; - until it has cooled down (around 1 hour). · Never pull the plug out of the socket by the cord. · Always unplug your appliance : - Before filling the removable water tank or rinsing out the boiler, - Before cleaning your generator, - After each use. [. . . ] · Always spray starch onto the reverse side of the fabric to be ironed. · Check that the removable water tank is securely in place and press the boiler reset button located on the control panel. · Fill the removable water tank and press the boiler reset button located on the control panel. · Increase the steam output (control dial on the control panel). [. . . ]