User manual ROWENTA DG7520F0

[. . . ] - Hold the iron by its handle in order to transport your steam generator - fig. 2 • Water recommendations Tap water • Rowenta steam generators are designed to be used with UNTREATED TAP WATER. If your water is very hard, Rowenta recommends mixing half untreated tap water with half distilled water which reduces the hardness. Some types of softeners, particularly those that use chemicals such as salt, can cause the appliance to leak or spit during use, this is notably the case with filtering jugs. [. . . ] In order to use this function, once the thermostat of your iron has been correctly set (see table above), position the steam output setting on the ECO segment. The ECO mode can be used with all types of fabrics. However, for very thick or creased fabrics, we recommend that you use the maximum steam output or the Boost function in order to ensure optimum results. € During ironing the iron indicator light switches on and off according to heating requirements but this has no effect on use. € To obtain steam, press on the steam control button beneath the iron handle and keep it pressed - fig. The steam will stop when you release the button. € Always spray starch on the reverse side of the fabric to be ironed. Recommendations: To prime the steam circuit, either before using the iron for the first time, or if you have not used the steam function for a few minutes, press the steam control button several times in a row - fig. 12, holding the iron away from your clothes. This will enable any cold water to be removed from the steam circuit. Use the Precision Shot • Your appliance comes with a Precision Shot function : It allows you to make a concentrated steam injection when ironing hard creases, details and difficult access areas. 10 • Re-filling the water tank • When there is no more steam and the”Water tank empty” light flashes fig. € Remove the water tank using the handle (on the front of the steam generator) - fig. If this occurs, remove the excess water. € Push the water tank into position until it "clicks" into place. Press the Restart button on the control panel. € The steam generator and the iron are ready for use when the steam indicator light is on and the iron indicator goes out. 13 • Easy descaling of your steam generator Do not use any descaling substances (vinegar, industrial descaling products, etc. ) when rinsing the scale collector: they could damage it. Emptying your steam Before generator, it must always be left to cool for 2 hours to avoid any risks of scalding. € To extend the life of your steam generator and avoid scale particles appearing on your ironing, your steam generator is equipped with a built-in scale collector. This scale collector, located in the boiler, automatically removes the scale that forms inside. [. . . ] possible causes The appliance is not switched on. You are using the steam control button before the iron is hot enough. Water has condensed in the pipes because you are using steam for the first time or you have not used it for some time. You are using the Boost function before your iron is hot enough. [. . . ]