User manual ROWENTA DW4010 D1

[. . . ] Safety lock (to hold the iron on the base unit) 8. "Calc away system" scale collector cover 11. On / Off switch PREPARATION 1 • Safety lock • Your steam generator is equipped with a safety lock that holds the iron on to the base unit in order to facilitate transport and storage: • Pull up – fig. The safety lock allows you to carry your steam generator by the iron handle: - place the iron on the iron rest of the steam generator and lock it into place (you will hear an audible “click” sound) – fig. [. . . ] This will enable any cold water to be removed from the steam circuit. Use the Precision Shot • Your appliance comes with a Precision Shot function : It allows you to make a concentrated steam injection when ironing hard creases, details and difficult access areas. € To use this function, press fully on the Precision Shot button located on top of your iron as many times as necessary – fig. Use the Precision Shot function carefully, as the steam comes out with exceptional force and could cause burns. 75 1800129089 DG8960 F0_110 x 154 28/01/13 10:21 Page76 8 • Vertical steam ironing • Set the iron temperature control to the maximum position (•••) and press the Boost/vertical steam button. € Hang the garment on a coat hanger and hold the fabric slightly taut with one hand. press repeatedly on the steam control button - fig. 12 (beneath the iron handle) moving the iron from top to bottom - fig. Examples of how to use the vertical steaming function: • Removing creases from delicate fabrics hung on a coat hanger that you do not want to bring into contact with the hot iron. € Refreshing a shirt or a suit just before putting it on. As steam is very hot: never attempt to remove creases from a garment while it is being worn, always hang garments on a coat hanger. For fabrics other than linen or cotton, hold the iron a few centimetres from the garment to avoid burning the fabric. 11 • Storing the steam generator • Turn off and unplug the steam generator. Place the iron on the iron rest on the steam generator. Lock the iron onto the base unit by pressing it until you hear an audible “click”, so your iron is secure - fig. Fold the steam cord in two and place it in its housing. Wind up the power cord and place it in its storage compartment. € Leave the steam generator to cool for at least one hour before putting it away if it is to be stored in a cupboard or confined space. You can then store your steam generator safely. MAINTENANCE AND CLEANING 12 • Cleaning the generator Do not use any cleaning or descaling products for cleaning the soleplate or the base-unit. Never hold the iron or the base unit under the tap. € The Iron soleplate: clean the soleplate of your iron when it is cool with a damp cloth or a non-abrasive sponge. [. . . ] If your water is very hard, rinse it more often. Never add this type of product in the water tank or in the boiler (see our recommendations regarding water to be used). Ensure linen is rinsed thoroughly to remove any soap deposits or chemicals on new garments which may be sucked up by the iron. see our recommendations regarding temperature control settings. [. . . ]