User manual ROWENTA DW6010 ECO INTELLIGENCE

[. . . ] Never dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any danger. • Never immerse your iron in water !€ Do not unplug your appliance by pulling on the cord. Always unplug your appliance : before filling - fig. [. . . ] TIP Always spray starch onto the reverse side of the fabric to be ironed. 11) and set the temperature to suit the type Your Steam Iron is equipped with the Eco Steam System. This function offers 3 steam settings for optimal ironing: - DRY position: For an ironing without steam, ideal for delicates or perfect finishes. - ECO position: For an optimized ironing with a steam output perfectly adapted to all fabric types. This setting ensures qualitative ironing results while saving energy. - BOOST position: For increased variable steam output to reach perfect result on thickest fabrics. 5 • Eco steam system 6 • Shot of steam (from temperature setting •• upwards) Press the shot of steam button to generate a powerful jet of steam (fig. Wait a few seconds between each shot before pressing the button again. (from temperature setting •• upwards) TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics. 7 • Vertical shot of steam Hold the iron to the vertical and press the shot of steam button ( fig. 17) to remove creases from suits, jackets, skirts, hanging curtains etc. Wait a few seconds between each shot before pressing the button again. FR 9 • Anti-Drip system* This prevents water escaping from the soleplate when the temperature is too low. 10 • Automatic electronic 3-position cut-out* If, although switched on, the appliance is not moved, it will automatically switch off and EN the auto off light will blink after the following intervals: - After 30 sec. , if the iron is left resting on the the soleplate or lying on its side. , if the iron is left resting on its heel. To switch the iron back on, move the iron gently. Open and close the steam control several times (fig. 16) to prevent the valve hole into the steam chamber from scaling or blocking up. Allow the appliance to cool down before storing the iron standing on its heel (fig. IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron placed down on the soleplate. [. . . ] Always spray starch onto the reverse side of the fabric to be ironed and clean your iron soleplate. Only use untreated tap water or mix half tap water with half distilled/demineralised water. Use the Self Clean function and clean your iron. Set the temperature control to a higher temperature. [. . . ]