User manual ROWENTA DZ5912D1

[. . . ] 21 1103910025DZ5000D1_110x220mm15/03/1311:14Page2 1103910025DZ5000D1_110x220mm15/03/1311:14Page1 SAFETY INSTRUCTIONS • Please read these instructions carefully and keep them for further references. € Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1 hour. € The iron must be used and rested on a flat, stable, heat-resistant surface. € When you place the iron on the iron rest, make sure that the surface on which you place it is stable. [. . . ] IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric. TIP Always spray starch onto the reverse side of the fabric to be ironed. 6 • Dry ironing Set the variable steam control to (fig. 11) and set the temperature to suit the type of material (care points •, ••, •••). 7 • Steam ironing You can steam iron from temperature setting •• upwards. Steam function* The steam quantity can be set to between no steam (minimum steam quantity) and (maximum steam quantity) (fig. We recommend setting to maximum steam quantity only when the iron is at temperature setting •••. auto Steam function* Set the steam button to (fig. 13) and the steam quantity will adjust automatically to the soleplate temperature 8 • Shot of steam (from temperature setting •• upwards) IMPORTANT Leave an interval of 4 seconds between each shot and wait until the flow of steam is finished before standing the iron on its heel. To generate a powerful jet of steam and remove (*) Depending on model 3 1103910025DZ5000D1_110x220mm15/03/1311:14Page4 9 • Vertical shot of steam (from temperature setting •• upwards) TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics. Hold the iron to the vertical and press the shot of steam button ( remove creases from suits, jackets, skirts, hanging curtains etc. 11 • Anti-Drip system* It prevents water escaping from the soleplate when the temperature is too low. 12 • Automatic electronic 3-position cut-off* If, although switched on, the appliance is not moved, it will automatically switch off and the auto off light will blink after the following intervals (fig. , if the iron is left standing on the soleplate or lying on its side . , if the iron is left standing on its heel. To switch the iron back on, move the iron gently. Open and close the steam control several times (fig. 19) to prevent the valve hole into the steam chamber from scaling or blocking up. 14 • Storing Allow the appliance to cool down before storing the iron standing on its heel (fig. IMPORTANT Do not wind the cord around the hot soleplate. [. . . ] None or too little steam is being emitted. Wait for the soleplate to reach the correct temperature. Brown streaks come through the holes inthe soleplate and stain the linen. Residues in the steam chamber or on the soleplate. [. . . ]