User manual ROWENTA EXPRESSO SILVER ART

[. . . ] It can also be removed, so that you can clean it regularly to keep it in perfect working order. For your safety, the filter holder is fitted with a locking system so that it remains in place when the pressure rises. eN 1- DESCRIPTION a b c d Water tank cover Removable water tank Cup tray Control panel: d. 1 Selection knob (coffee or steam) e Position for the filter holder f Filter holder with ejection system for the used coffee or pod and progressive compression of the ground coffee or pod: OPTIPRESS system. [. . . ] This system permits easy, simple, clean and comfortable use of your machine. € Before removing the removable tank, remember to place the selector d1 in the position (fig. € Fill the tank with cold water and fit it back onto the appliance (fig. € Switch on the appliance by pressing the ON/OFF button d2 . € The LED flashes during preheating, then remains lit. INDIVIDUAL PROGRAMMING OF THE VOLUME OF COFFEE: To change the pre-programmed amount of water, proceed as follows: • Fill the water tank and turn the machine on (fig. € Put a spoonful of coffee in the filter by using a measuring spoon or use an E. 7 IFU_RO_PERFECTO_4400_NC00025894-01_eo 27/09/11 11:26 Page8 EN • Put the filter holder in place and lock it by turning it to the right as far as it will go, up to the stop (fig. € Hold down the "1 cup" button (> 3 sec) until the "1 cup" light flashes quickly. € When the desired amount of espresso is obtained, press the "1 cup" button. This amount will be saved automatically. • When frothing is completed , stop the appliance device (switch d1 in position )). € When the selector d1 is in the position , the appliance cools down automatically. During the cooling down phase, the LED of the ON/OFF button flashes, and hot water runs into the drip tray. When the optimal temperature for preparing an espresso is reached, the LED remains lit. Once the steam has been stopped, clean the steam nozzle immediately and thoroughly using a damp sponge (to avoid residues from sticking) and let a little more steam run through into free air to rinse the inside of the nozzle. The filter holder The appliance that you have purchased is equipped with a removable ejecting filter holder, which allows you to maintain it in perfect working order. We recommend that you clean it each time after use. These removal/fitting operations must be carried out when the machine has cooled down. Removal of the filter holder: • Remove the filter holder from your machine. € Dispose of the used coffee or pod by pressing the "push" button (fig. € Remove the back of the filter holder by turning to the left, while pressing in the two brackets. [. . . ] the pump has been drained due to lack of water. The removable water tank is not fitted correctly. The steam nozzle does not froth the milk. If the cause of the problem cannot be determined, contact an approved service centre. [. . . ]