User manual ROWENTA IR 5010 FO

[. . . ] It cannot therefore be used for any industrial purpose. € Do not use your appliance in a dusty enclosed space or in a room where there may be fire hazards. € Never insert any object inside the appliance (e. € Do not place the appliance just below a power socket. [. . . ] 3) to its initial position O (light off) and unplug the appliance. € Important: Do not use the appliance in any small room where there may be people who are unable to leave the room without assistance, unless they are under constant supervision. € Important: certain parts of this appliance may become very hot and cause burns. Special supervision is required in places where there are children or vulnerable people present. This "IPX1" appliance has been made in such a way that it can be used in all rooms of the home, including those where water may fall from above (kitchen, bathroom, etc…). The electrical wiring in the room, the way the appliance is plugged in to the mains and the way it is used must comply with the standards in force in your country. 4- SAFETY In the event of the appliance tipping forwards or backwards, a safety system which automatically stops the current will activate. Put the appliance back into the vertical position and it will start working again. Fan part: In the event of this part becoming abnormally hot, a safety system will stop the blower, and then start it up again automatically once it has cooled down. If the fault persists or becomes more serious a thermic fuse will stop the blower permanently and the appliance will have to be taken to an approved service centre. 5- STARTING THE APPLIANCE Before using for the first time, check that your mains supply voltage does indeed correspond to that indicated on the appliance and that the power of your mains supply is suitable for the power indicated on the appliance. Your appliance must be used with an earthed socket. Before switching on your appliance make sure that: - the feet of the appliance are correctly fitted (see fig. 4-5-6) - the appliance is in the right position (see fig. 7): There must be no object (furniture, curtains…), wall, partition wall less than 1 m behind or from the sides of the appliance, and less than 1 m from the “Radiant” part or the “Fan” part of the appliance. - the air intake and outlet grilles are totally free of any obstruction, - the appliance is on a flat and stable surface. - the tubes of the radiator part are not cracked or broken. 6- OPERATION • Choice of operation: Select the type of heating you want, using the button A (fig. 3), and by moving the button marker so that it is opposite the symbol: : Stop : Radiant 1000W : Radiant 1000W+Fan 1000W : Fan 2000W • Light : Power on light C (fig. 3): it comes on when your appliance is switched on. [. . . ] Whilst the appliance is not in use, it must be stored in a room free of any dampness. 9- IF YOU HAVE A PROBLEM Never dismantle the appliance on your own. An appliance which has been incorrectly repaired can be dangerous to the user. Do not use your appliance and contact an Approved Service Centre if: - your appliance has had a fall, - your appliance is not working properly. [. . . ]