User manual ROWENTA RH8753

[. . . ] 18 11 RO_AIR_FORCE_EXTREME_903097_05_V8_903097/05 08/04/13 14:40 Page12 SECURITY ADVICE This appliance is not designed to be used by individuals (including children) with reduced physical, sensory or mental capacities, nor by individuals lacking experience or knowledge in the use of the appliance, unless they have the benefit of being under the surveillance of a responsible person, or of having received proper instructions. It is advisable to keep an eye on children in order to make sure that they do not use the appliance as a toy. This appliance may be used by children over eight (8) years old and by individuals with reduced physical, sensory or mental capacities, or lacking experience or knowledge, as long as they are properly supervised by a responsible person, as long as they have received instruction concerning the safe use of the appliance, and as long as all possible risks have been addressed. Children should not play with the appliance. [. . . ] It is now time to recharge your appliance. € Before you can use your vacuum cleaner again, you will need to recharge it for at least ten (10) minutes. 14 * May vary according to model RO_AIR_FORCE_EXTREME_903097_05_V8_903097/05 08/04/13 14:40 Page15 • If the appliance does not turn on after this time, and the light charge signal continues to flicker, it means that the battery is still uncharged. In this case, you will need to charge it. USING THE ELECTRO-BRUSH The electro-brush is a rotating, motorized brush that guarantees maximum cleaning effectiveness by allowing the appliance to suck up dirt and clean in depth. The bristles, located all along the brush, remove threads, hair and fur that might be caught on the surface of rugs and carpets. Please note: If the vacuum head adheres too closely to the surface you are cleaning, change the speed to « Minimum ». ATTENTION: Do not vacuum large fragments of broken objects, as they could block and damage the brush. Do not use the electro-brush on long hair carpets, on animal fur, or on fringes. REMOVING AND CLEANING THE ELECTRO-BRUSH ATTENTION: Always turn off the appliance and unplug it before storing or cleaning. Using the tool provided with the appliance (15), press in the two latches located on each side of the lower side of the Delta head (fig. Lift the trap located on top of the electro-brush (fig. Remove the electro-brush and its lateral bearing in order to clean them (fig. Carefully remove any threads, hair, fur, etc. Once clean, replace the electro-brush and its lateral bearing (fig. 11), then replace the trap over it (fig. Finally, using the tool provided with the appliance, close both latches (fig. FOR YOUR SAFETY • Do not touch any rotating parts before you turn off and unplug the vacuum cleaner. € Do not use the appliance on wet surfaces. € Do not immerse the appliance in water. ELECTRO-BRUSH MALFUNCTION The electro-brush does not function properly or makes an unusual sound • Either the rotating brush or the axis is blocked: turn off the appliance and clean them. € The brush is worn out: visit an authorized Service Center in order to have the brush changed. [. . . ] EN REPAIRS IMPORTANT: If you notice that your vacuum cleaner is not functioning properly, before any revision, turn it off by placing the Stop/Start button in the Stop position. Repairs should only be carried out by specialists using original replacement parts. To attempt the repair of an electronic appliance at home may be hazardous to the user. If your vacuum cleaner does not start Make sure that the charger is completely unplugged from the appliance. [. . . ]