User manual ROWENTA RO4725FA

[. . . ] Le support accessoires reste sur le tube, les accessoires s’enlèvent du support, celui-ci restant fixé sur le tube (fig. Fit the turbobrush to the end of the tube. Fit the furniture crevice tool onto the end of the power nozzle or the tube. 13 SAFETY RECOMMENDATIONS For your safety, this appliance conforms to the applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental, etc. [. . . ] € For corners and other areas that are difficult to reach: use the crevice tool*. 2 • Plugging in the electrical power cord and using the vacuum cleaner Fully unroll the cord, plug in your vacuum cleaner and press the On/Off pedal, (fig. Set the power using the vacuum cleaner’s power control, if your model is equipped with a High Control wand (fig. 7) you can also adjust the vacuum power using the 3 position slider* : • Position • Position • Position for fabrics and furniture (fig. *Depending on model: this is either equipment specific to certain models or available as an optional accessory. If your appliance is equipped with the Compact System with folding tubes: • Retract the telescopic tubes (fig. 11) and press the «Push» button to open the tube and fold it. € If your appliance is equipped with CLIP’N’STORE, attach your hose to the accessory clip for easier storage (fig. After use, stop your appliance by pressing on the on/off pedal and unplug it (fig. Stow the cable by pressing the automatic cable rewind pedal (fig. In the upright position, place the suction unit in the parking position (fig. You can then carry and store your vacuum cleaner in the CARE AND CLEANING IMPORTANT Always turn off and unplug your appliance before maintenance or cleaning. The bag full indicator shows you when the bag is full or saturated. If you notice that your vacuum cleaner is less efficient, select the maximum power and hold the nozzle off the floor. If the indicator remains red, replace the bag. Open the cover on your vacuum cleaner (fig. IMPORTANT Do not reuse the wonderbag, it is a single use bag Place a new wonderbag in the bag holder, using the ring (fig. Position the bag and open it out inside the compartment (fig. Make sure that the bag is in the correct position before closing the cover. IMPORTANT Never operate the vacuum cleaner without a bag. IMPORTANT Your appliance is equipped (depending on the model) with a safety system ensuring that a bag is present (the lid will not close if you have not installed a bag). 2 • Change the HEPA* filter cartridge or the microfilter* 2. [. . . ] Fit a new bag or empty the fabric dust bag. • The filter is full: change the HEPA* filter cassette (ref. ZR 0029 01) and fit it back into position (see page 16 paragraph 2). € If the manual suction regulator on the grip is open, close the manual suction regulator*. [. . . ]