User manual ROWENTA RO6799EB

[. . . ] 6 RO_ASPIRATEUR_EFC_765275-01_765275_01 11/07/14 14:24 Page7 EN GUARANTEE • This appliance is for domestic use only; any misuse or use that does not conform to the instructions will release the brand from all liability and the guarantee will be cancelled. € Read the instructions for use carefully before using your appliance for the first time: Rowenta shall accept no liability in the event of any use that does not comply with the instructions. SAFETY INSTRUCTIONS For your safety, this appliance complies with all applicable standards and regulations (Low Voltage 2006/95/EC, Electromagnetic Compatibility 2004/108/EC, Environmental directives, etc. € This appliance is not designed to be used by persons (including children) with reduced physical, sensory or mental capabilities, or by people with no prior knowledge or experience, except where they have benefited from supervision or previous instructions relating to the use of the appliance, from a person responsible for their safety. [. . . ] If you have the ERGO COMFORT chain of accessories with the tube/nozzle Locking system (II)* - Fit the telescopic metal tube to the end of the nozzle until you hear a 'click' (Fig 3) (To remove, press the tube lock button and pull). - Fit the nozzle for all floor types* (II. 20) to the end of the telescopic metal tube until you hear a 'click' (Fig. 5a) (To remove, press the tube lock button and pull). - Adjust the telescopic metal tube to the desired length using the telescopic system (Fig 5b). ERGONOMIC RECOMMENDATIONS Ergonomic, the ERGO COMFORT range has been designed to facilitate and improve user comfort when vacuuming. to prevent bending over and to ensure upright posture , make sure to: 1. Adjust the length of the ERGO COMFORT telescopic metal tube to your body size (fig. Place your second hand in front of the ERGO COMFORT nozzle handle (fig. *According to model: these parts are specific to certain models or they are accessories that can be purchased separately. Fit the corresponding accessory to the end of the metal telescopic tube or the nozzle: IMPORTANT: Always switch off and unplug your vacuum cleaner before changing the accessories. - For rugs and carpets: use the multi-surface nozzle in the retracted brush position or the Turbobrush* (fibres and animal hairs). - For smooth floors with joins (tiled floors) : use the 2position nozzle (I-20* II-20*, depending on the model) on the smooth floor setting (extended brush position), or, for a better result, use the nozzle for smooth floors with joins without the removable brush (I-27a* II-27a*, depending on the model). - For smooth floors, including delicate smooth floors (parquet flooring), use the 2-position nozzle setting (I-20* II20*, depending on the model) on the smooth floor setting (extended brush position), or, for a better result, use the nozzle for smooth floors with the removable brush (I-27b* II27b* depending on the model). IMPORTANT : The nozzle for smooth floors with joins (I-27a* II-27a*) is used to measure the performance related to the energy label. The nozzle allows your appliance to achieve optimum dust removal performance on smooth floors with joins. - For corners and hard-to-reach areas: use the telescopic crevice nozzle*. - For furniture and fragile surfaces: use the integrated nozzle brush (EASY BRUSH) or the upholstery nozzle*. 2 • Plugging in the power cord and switching on the appliance Unwind the power cord completely, plug in your vacuum cleaner and press the ON/OFF button (fig. IMPORTANT: do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter). 9 RO_ASPIRATEUR_EFC_765275-01_765275_01 11/07/14 14:24 Page10 EN USE Set the suction power using the manual power switch* on the power nozzle (fig. 9): • Position • Position • Position (MIN) for vacuuming delicate fabrics (curtains, textiles) (Medium) for daily vacuuming of all types of surfaces that are not very dirty. [. . . ] if the HEPA filter is damaged , change it. If your vacuum cleaner suction is not working properly or is making a whistling noise • An accessory, the tube, hose, air/dust separator (14a) or the separation compartment (14b) is partially blocked: unblock it. € The dust compartment is full: empty and wash it. € The vacuum lid is not positioned correctly: close the lid correctly. [. . . ]