User manual ROWENTA RO8370EA SILENCE FORCE

[. . . ] SAFETY INSTRUCTIONS For your safety, this appliance complies with all applicable standards and regulations (Low Voltage 2006/95/EC, Electromagnetic Compatibility 2005/108/EC, Environmental directives, etc. Use and store the appliance out of the reach of children. Do not place the nozzle or the end of the tube near the eyes or ears. Do not vacuum wet surfaces, any type of liquids, hot substances, supersmooth substances (platinum, cement, ash, etc. [. . . ] If you have any difficulties in finding accessories or filters for this vacuum cleaner, contact the Rowenta Customer Service. USE 1 • Fitting the elements onto the appliance Clip the end of the hose to the suction inlet located at the front of the appliance (fig. To remove, unclip the end using the clip and remove. Fix the accessory support to the notch in the parking position located at the back of the vaccuum cleaner (fig. Note: The accessory support does not need to be removed to open the vacuum cleaner lid. €¢ Fit the metal telescopic tube to the end of the nozzle until you hear a click indicating that it is locked (fig. To remove, press the tube lock button and remove. €¢ Fit the multi-surface nozzle (23) to the end of the metal telescopic tube until you hear a click indicating that it is locked (fig. To remove, press the nozzle lock button and remove. €¢ Adjust the metal telescopic tube to the desired length using the telescopic system (TELESCOPIC SYSTEM) (fig. Fit the corresponding accessory to the end of the metal telescopic tube or the nozzle: - For rugs and carpets: use the multi-surface nozzle in the retracted brush nozzle position or the Turbo-brush* (fibres and animal hairs). (H)EPA ([High] Efficiency Particulate Air Filter) filters retain the finest particles. Thanks to the (H)EPA filter, the air released into the room is cleaner than the air suctioned. IMPORTANT: always switch off and unplug your vacuum cleaner before cleaning or servicing. Check and clean your vacuum cleaner and the different filters regularly. IMPORTANT: do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter). 2 • Cleaning the black foam filter (18a) IMPORTANT: clean the black foam filter every 6 months or when the suction is no longer satisfactory. Leave to dry for at least 12 hours before refitting. ATTENTION: let the black foam filter dry completely and make sure it is completely dry before placing it back in the appliance. Reposition the black foam filter and close the cover. 3 • Cleaning the microfilter (18b) IMPORTANT: clean the microfilter every 6 months. Remove the filtration cassette (18) then separate the black foam filter (18a) from the microfilter (18b) (fig. [. . . ] Remove the separation compartment (4c) by turning slightly to the left (fig. 35) then separate the two components (fig. Wash the components (4a+b and 4c) in clear water (fig. Refit the filter system components (4): - Reposition the separation compartment (4c) on the separation system (4a+b) (fig. [. . . ]