User manual ROWENTA STEAM FORCE DW9220D1

[. . . ] To avoid any danger, have it inspected in an approved service centre. • The surfaces which are marked with this sign and the soleplate are very hot during the use of the appliances. Don’t touch these surfaces before the iron is cooled down. 1 EN 1103909885 DW9220 DW9225 D1_110x220mm 26/02/13 08:57 Page2 IMPORTANT RECOMMANDATIONS • The voltage of your electrical installation must correspond to that of the iron (220-240V). [. . . ] This is parf of manufacturing process and is not harmful to you or your garments. You may accelerate this by using the self cleaning function (fig. 13a - 13b) and shaking the iron gently. WHAT WATER MAY BE USED ? Your iron has been designed to operate using untreated tap water. If in doubt, check with your local water authority. However, if your water is very hard, you can mix 50% untreated tap water with 50% distilled or demineralised water. IMPORTANT Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: water from tumble dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Also do not use boiling, or bottled mineral water. USE 1 • Filling the water tank • Before filling the water tank, unplug the iron fig. 2. • Set the temperature control dial fig. 3 on position (Min. ) • Open the filling inlet fig. 4. Close the filling inlet and return the iron to the horizontal position. • You can plug in your iron fig. 6. 2 • Setting the temperature Your iron is equipped with the Autosteam function, it automatically adjusts the steam amount and the temperature based on the selected fabric for optimum results. Select the fabric to be ironed on the thermostat dial. For perfect results, an optimum position for each fabric has been pre-defined. You can also set your iron based on the international temperature measurements •, ••, •••. Ensure your thermostat dial is positioned on these settings. When your iron reaches the required temperature, the thermostat indicator turns off fig. 7. You can start ironing. (*) Depending on model 3 1103909885 DW9220 DW9225 D1_110x220mm 26/02/13 08:57 Page4 FABRIC Nylon (Synthetic fibres, e. g. viscose, polyester) THERMOSTAT THERMOSTAT IRONING INDICATION LABEL NYLON silk SILK wool WOOL cotton COTTON linen LINEN IMPORTANT The iron takes longer to cool down than to heat up. We recommend that you start with fabrics to be ironed at a low temperature. For mixed fabrics set the temperature for the most delicate fabric. [. . . ] Fill the water tank with untreated tap water up to the max mark and heat the iron to the ••• temperature. Unplug the iron and hold it over a sink horizontally. Push the self clean button for 1 minute fig. 13a-13b and shake the iron gently: steam will now begin to build up. [. . . ]