User manual ROWENTA VERTICAL STEAMER

[. . . ] Commercial Garment Steamer Instructions for Use IMPORTANT SAFETY INSTRUCTIONS When using your appliance, basic precautions should always be followed, including the following: Read all instructions before use. Use appliance for its intended use only. SPECIAL INSTRUCTIONS 1. To avoid a circuit overload, do not operate a high wattage appliance on the same circuit. If an extension cord is absolutely necessary, the marked electrical rating should be at least as great as the electrical rating of the appliance. [. . . ] · If steaming in a low position near floor, straighten hose up and out frequently to keep clear of condensation. If hose becomes clogged, it will make a gurgling noise. · Heavier fabrics may require repeated steaming. · Exercise caution at all times. ACCESSORIES (depending on model) Reminder: When using accessories steam only in an up and down vertical motion. Never use steamer in a horizontal position and never tilt it in a backward position. Before using any of the accessories on upholstery or garments, be sure to consult the manufacturer regarding their recommendations. We also recommend testing on an unobtrusive area. Lint Pad The lint pad removes hair, lint and animal fur for a professional finish. · To use the lint pad, slowly brush the clothing with the grain or nap of the fabric. · The pad can be cleaned by brushing in the opposite direction. We recommend cleaning on an old cloth that can be discarded. (Note: The lint pad does not attach to the steamer. ) Upholstery Brush The upholstery brush is used to aid steam penetration into difficult, heavy fabrics for faster results. · Be sure unit is unplugged and completely cool before attaching accessories. · Attach the upholstery brush to the steam head by lining up the bottom of the brush with the bottom of the steam head. Gently push the top of the brush into place on the steam head until it clicks into place. · Gently brush the area to be steamed with the grain or nap of the fabric. · Remove the upholstery brush once unit is unplugged and completely cool. Remove it by pressing on the release button on top of brush while pulling it forward. Fabric Brush The fabric brush opens the weave of the fabric for better steam penetration. · Be sure unit is unplugged and completely cool before attaching accessories. · Attach the fabric brush to the steam head by lining up the bottom of the brush with the bottom of the steam head. Gently push the top of the brush into place on the steam head until it clicks into place. [. . . ] Grasp the steam head with the steam vents pointing away from you. Start steaming by touching material lightly with steaming head and moving in an up/down vertical motion. Begin at the bottom of the garment and move in an upward direction. This allows any condensation to flow back into the steamer. [. . . ]