User manual ROWENTA X-TREM POWER CYCLONIC RO6289.11

[. . . ] 7 EN SAFETY INSTRUCTIONS Read these instructions carefully before using your appliance for the first time and keep to hand for future reference: failure to comply with the instructions will release the manufacturer from all responsibility. €¢For your safety, this appliance meets applicable standards and regulations (Directives on Low Voltage, Electromagnetic Compatibility, Environment, etc. €¢This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities or lack of experience and knowledge, unless they are supervised or have been given instructions beforehand concerning use of the appliance by a person responsible for their safety. €¢Children should be supervised to ensure that they do not play with the appliance. [. . . ] - For wood and hard floors: use the multi-surface nozzle (20 or 21) in the exterior brush position or, for best results, use the parquet nozzle*. - For corners and hidden spots: use the crevice nozzle*. - For upholstery and delicate surfaces: use the upholstery brush integrated to the ERGO COMFORT nozzle (EASY BRUSH) or the upholstery nozzle*. Never turn your vacuum cleaner on if the dust box (12) and the filtration system (case) are not in place. 2 • Plugging the cord in and turning on the appliance Unwind the power cord completely, plug in your vacuum cleaner (Fig 6) and press the ON/OFF pedal (Fig 7). Note: you can use your vacuum cleaner in the horizontal position (sleigh) but also in vertical position, especially when vacuuming stairs or curtains. With the electronic power control switch (Fig 8) ?With the mechanical power control on the butt: open the regulation shutter slider to manually decrease the vacuuming power and thus keep the nozzle from getting stuck to the surface being vacuumed (fig. 9) ex: sheer curtains , fragile surfaces. €¢ (MIN) • (MID) • (MAX) position for vacuuming delicate fabrics (sheer curtains, textiles) position for daily vacuuming of all floor types and in the event of weak dirt marks position for vacuuming hard floors, rugs and carpets in the event of strong dirt marks 3 • Storage and transport of the appliance After use, switch off your vacuum cleaner by pressing the ON/OFF pedal and unplug it (fig. Rewind the power cord by pressing the power cord rewind pedal (fig. In vertical position, place the nozzle in the parking position (fig. In vertical position, place the nozzle in the parking position (fig. You will thus be able to transport and store your vacuum cleaner in the parking position (fig. CLEANING AND MAINTENANCE IMPORTANT: Always turn off and disconnect your vacuum cleaner before performing any maintenance procedures. €¢ Empty the dust box over a dustbin (Fig. 19) • Place the lid back on the box by putting the corresponding parts on the appropriate notches (Fig. 20), then pull it down until you hear a 'CLICK' (Fig. €¢ Place the box back in its casing (Fig. 1 - Empty the dust box IMPORTANT Empty the dust box after each use. €¢ Withdraw the tube from the vacuum opening (Fig. 2) • Open the lid of your vacuum cleaner (fig. [. . . ] €¢ The electronic power regulator (9) is set at minimum: increase the power using the electronic power regulator (unless you are cleaning fragile fabrics). If the lid does not close (detector action 14*) • Verify that the HEPA filter case (16) is there and that it is correctly positioned. €¢ Make sure that the dust box (12) is correctly positioned in the dust tray housing (11). If it is difficult to move the nozzle • Reduce the power by opening the mechanical power control on the butt (18b) or by moving the electronic power control switch (9) towards the MIN position. [. . . ]