User manual ROYAL SOVEREIGN RSC-1650H

[. . . ] Do not operate machine if electrical plug or power cord is damaged. Turn off the power when unattended or not in use. Unplug machine before moving it or when it is not in use for an extended period of time. This machine is intended for indoor use only. [. . . ] Place the film from lower shaft beneath the film from the upper roller which is already meiting. and unwind films of both rollers 30~40cm(1~1. 3ft) for loosing the tension. Set speed at 1 and press the RUN button. The films will be fed into the machine and will come out from the rear site of machine. Check the status of lamination and place the pressure lever at lamination mode. -7EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 CONTROL OF ROLLER PRESSURE ***Methods of controlling pressure of the roller** 1. For setting, pull the pressure lever out and turn the lever to following the indication 2. OPEN/15mm(Board) : For laminating 15mm thick board (RSC-1650H/1650C) 3. 10~13mm(Board) : For laminating 10~13mm thick board 4. 5~7mm(Board) : For laminating 5~7mm thick board 5. 1mm(Hard Board) : For laminating 1mm thick board 6. Laminating : For laminating 32~250micron thick film -8EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 INSTRUCTIONS FOR CONTROL PANEL We designed this machine standing by user's convenience. You can manipulate speed and temperature . ***Terms*** 3 4 3 2 5 2 6 6 1 1 -9EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 1. FUNCTIONS OF CONTROL PANEL 1 2 3 4 5 6 RUN/STOP BUTTON : Run or stop the rollers SPEED BUTTON : Increase or decrease speed LED OF SPEED : Display or speed LED OF TEMP. : Display temperature TEMP. BUTTON : Increase or decrease temperature REVERSE BUTTON : To make the rollers run backward 2. HOW TO USE BUTTONS 1 RUN / STOP BUTTON Push the RUN button to stop it. button in order to run rollers and push STOP 2 SPEED BUTTON Push the SPEED button button to increase the speed, push the speed to decrease the speed. 5 TEMP. button to increase the temperature, push the to decrease. REV 6 REVERSE BUTTON Stay pressing REVERSE button to have . The roller run backward. - 10 EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 LAMINATING STEPS 1. Put cold roll film on upper bar. (Set the same as methord of the HOT film for protect paper of lower part) 2. Pull COLD film, and fix it so that backside protecting paper can be wound on take-up mandrel clockwise. (Revolve core to make protectingpaper tight a little bit. ) 3. Set pressure lever at the proper position following to your lamination condition. [. . . ] 6. Check the chain linking each gear is not loosened. The limit tension allowed is 3mm. - 13 EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 It's not out of order Symptom *Rollers do not operate after press RUN button in. Check the s/w of safety cover is right. Cause 1. Power cord may not be plugged CHECK POINT 1. Check the power cord. *Wrinkled lamination result 1. [. . . ]