User manual RUSSELL HOBBS 14387

[. . . ] Keep the kettle, stand, and cable away from the edges of worktops and out of reach of children. 7 Route the cable so it doesn't overhang, and can't be tripped over or caught. 9 Consume filtered water within two days. 10 Unplug the stand when not in use, before moving and before cleaning. [. . . ] 22 Push the filter gently up, against the seal, and turn it anti-clockwise (about 1. 5cm) to lock it into the reservoir. 23 Slide the release button towards the handle, and hold it there. b) slide the tabs on the front of the lid into the slots in the front of the reservoir c) lower the rear of the lid into the reservoir d) return the release button to its rest position rinse the filter 24 Slide the fill button towards the kettle, to open the lid segments, and hold it there. 25 Fill the reservoir, through the lid, with about a litre of water. , It's best to measure the water with a jug. It's difficult to measure a litre from a tap. 26 Return the fill button to its rest position. 27 Wait till the water runs through the filter, then pour it away. 28 Do this twice, fill again, and it's ready for use. the filter life-timer 29 After you fit a new filter, you must set the filter life-timer, so it can tell you when the filter needs replacing. 30 The first time you see the timer, the display will be blank, to conserve the battery. 31 Any other time you need to set it, it'll be flashing, to tell you the filter needs replacing. 32 The display has 6 parts: bullseye, inner ring, and 4 outer segments. set the life-timer 33 If you've fitted a standard two-month filter, press and hold the RESET button for 10-14 seconds, then let go (for a one-month filter, see "troubleshooting", page 7). 34 The inner ring and bullseye will flash alternately (shown here in grey), and the top left outer segment will turn black (shown here in black). , If the display shows anything else, see "troubleshooting", page 7. 35 That's it ­ the life-timer is set for a two-month filter. 36 Over the next two months (actually, it's 60 days), the display will change thus: (grey = flashing, black = black, white = invisible) when to change the filter 37 When the filter needs replacing, the display will go mad ­ in addition to the bullseye and inner ring flashing, all 4 outer segments will flash ­ you can't miss it. 5 everyday use 38 Put the stand on a stable, level surface. 39 Route the cable so it doesn't overhang, and can't be caught or tripped over. fill the reservoir 40 Remove the kettle from the stand. caution keep clear, if it has recently boiled, steam may escape from the lid segments 41 Slide the fill button towards the kettle, to open the lid segments, and hold it there. 42 Fill the reservoir, through the lid, with about a litre of water. 43 It's best to measure the water with a jug. It's difficult to measure a litre from a tap. [. . . ] 24 Your local authority will have facilities for disposing of these batteries in an environmentally friendly way. When it runs out, you'll have to replace the life-timer. Spares are available from Customer Service Department. 26 To replace the life-timer, lever it out with something blunt, like the point of a spoon. [. . . ]