User manual RUSSELL HOBBS 14582

[. . . ] 7 Keep the appliance and the cable away from hotplates, hobs or burners. 8 Don't try to sit the mixer on it's end ­ it'll fall over. 9 Don't use the mixer for any purpose other than those described in these instructions. 10 Don't use the mixer if it's damaged or malfunctions. [. . . ] 23 Thinner mixes suggest shorter timings and higher speeds. 24 Speed and timing aren't usually critical. Switch on, switch off, look/feel/taste, till it feels right. care and maintenance 25 Switch off (0) before cleaning. 27 Wipe the handle with a damp cloth ­ don't let liquid get inside the mixer. 28 Wash the whisk, beater, and whiz in warm, soapy water. 31 Don't put the mixer in water or any other liquid. 32 Don't put any part of the appliance in a dishwasher. 33 Don't use harsh or abrasive cleaning agents or solvents. charging 34 The battery loses its charge slowly when it's not in use. 35 A charge should last a couple of days in "average" use. 36 Recharge for at least 12 hours ­ overnight is usually easiest. 37 Don't leave the adapter permanently connected ­ you'll reduce the battery life. 38 The adapter gets a bit hot ­ don't worry about it. 39 Use the mixer only with the adapter supplied, and vice versa. 4 wall mounting We cannot accept responsibility for any damage or loss of any nature arising out of this operation. If you're in any doubt about your ability to do this, employ a craftsman to do it for you. You'll need: a) 2 dome-head screws ­ the underside of the heads must be flat, not countersunk, and the heads should be small enough to pass through the bottom of the "keyhole" shaped screw holes b) 2 wall plugs ­ these must fit the screws c) a drill and bit to fit the screws or wall plugs d) a screwdriver to fit the screws what to do: 1 Choose a location: close to a power socket, out of reach of children, and safe from the risk of accidental knocks. 2 Check for pipes and wires in, on, or behind the location. If you find any, go back to point 1 and choose another location. 4 Use the guide on the left of page 2 of this booklet. 5 Turn page 2 through 90 degrees, so that the edge of the page is horizontal. 6 Hold the page against the wall, and push a pin through the crosses to mark the wall. 8 Insert the wall plugs (if necessary), and push them in till they're flush with the wall surface. You may need to give them a couple of (gentle) taps with a hammer. [. . . ] It's on the rating plate (usually underneath the product). The product isn't user-serviceable. If it's not working, read the instructions, check that it's fully charged. If it's still not working, consult your retailer. [. . . ]