User manual RUSSELL HOBBS 15066

[. . . ] 8 Take care when pouring ­ pour slowly, and don't over-tilt the kettle. 9 Don't switch on unless the kettle contains at least 2 cups of water. 10 Don't fill past the max mark (inside the kettle), or it may spit boiling water. 11 Remove the kettle from its stand before filling or pouring. [. . . ] 23 If you get the temperature wrong, and want to change it: either pour the hot water away, and refill with cold water or wait till the kettle cools down (it'll cool a bit faster if you open the lid) keep warm 24 If you want the kettle to keep the water at the set temperature, press and release the 9 button. , This function only works at the 90, 85, 80, 75, 70, 65, and 60 settings. 25 A dot will appear on the bottom right of the display to show that the keep warm function is operating. 26 When the keep warm function is operating, the display won't switch off after a minute, it'll remain lit. 27 The element will switch on intermittently, to keep the water hot. 28 When it's heating, the display will flash. The flashing will stop when the water again reaches the set temperature. 29 To cancel the keep warm function, press and release the 9 button again ­ the dot will disappear. caution keep an eye on the water level ­ don't let the level get below 2 cups 30 To switch off manually, press and release 2. 31 This will switch off the element and the display, and put the kettle into standby mode. 32 To save electricity, unplug the stand. 4 switching off general 33 Remove the kettle from the stand before pouring. 34 To avoid the risk of splashing, pour slowly and don't over-tilt the kettle. 35 Don't tilt the kettle backwards ­ water might get on to the control area. 36 If this happens, let the kettle dry before use ­ sit it somewhere warm for 12 hours. 37 When you lift the kettle, you may see moisture on the stand. Don't worry ­ it's the steam used to switch the kettle off automatically, which then condenses and escapes via vents under the kettle. 38 Don't worry about discolouration on the floor of the kettle. It's due to the bonding of the element to the kettle floor. using with insufficient water 39 This will shorten the life of the element. 40 A boil-dry cut-out will switch the kettle off. 41 To reset the cut-out, you must remove the kettle from the stand and let it go cold. 42 Sit the kettle on the work surface till it's cold. [. . . ] It's on the rating plate (usually underneath the product). The product isn't user-serviceable. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. If it's still not working, consult your retailer. [. . . ]