User manual RUSSELL HOBBS DELUXE COFFEE MAKER 18118

[. . . ] 9 Fill with at least 2 cups of water, but not above the max mark. 10 Put the carafe on the hotplate before switching the coffee maker on. 11 If you want to stop the coffee maker while it's brewing, press the X button. 12 Let the coffee maker cool for about 10 minutes before adding water or re­using, to avoid spitting. [. . . ] 4 keep warm 30 When the coffee maker has finished brewing, it'll automatically go into keep warm mode. 31 The X light will flash, and the hotplate will keep the carafe warm for up to 2 hours. 32 The display will change to 0:00, then it'll count up , to show you how long the coffee has been sitting. auto shut-off 33 After 2 hours, it'll turn the coffee maker off. 34 We don't recommend leaving coffee for two hours. In our experience, chemical changes in the coffee liquor start to affect the flavour after about an hour . 35 While it's probably still drinkable, it's not at its best, so we suggest you pour it away and make a fresh pot. 36 When the coffee runs out, or if you decide you don't want any more, press the X button ­ the X light will go out. 37 Unplug, and let the coffee maker and carafe cool down fully before cleaning, or for about 10 minutes before refilling. caution raising the lid before the coffee maker has cooled down may release steam, creating a scald hazard finished? brew strength Y 38 Use this feature if you're brewing less than 5 cups of coffee. It slows the brewing process, so your coffee will have the same strength as coffee from a full carafe. 39 You may press the brew strength button Y before or during the brewing process, to activate or deactivate the brew strength feature. 40 Press the Y button to activate the brew strength feature, the Y light will glow and a "smiley" mug will show in the top left of the display. 41 Press the Y button again to deactivate the brew strength feature, the Y light will go out, and the "smiley" mug will disappear from the display. If it isn't, press the X button to turn it off. 43 Initially, the display will show 12:00 AM. a) the display will show AM for morning, and PM for afternoon b) press the h/min button, and keep it pressed till the display flashes (2 seconds) c) press and release the h/min button till the correct hour is shown (hold it down to "fast forward" the display) d) press and release the T button ­ the minutes side of the display will flash e) press and release the h/min button till the correct minute is shown f) leave the controls alone for 5 seconds ­ the display will settle at the correct time , If you overshoot, you can't step back. Either go right round (24 hours or 60 minutes), or unplug the coffee maker, to reset the display to 12:00 AM. 45 The clock will retain its settings till the coffee maker is unplugged. It'll reset to 12:00 AM next time you plug it in. 5 coffee later 46 Set the timer to the time you want to start brewing. a) the display will show AM for morning, and PM for afternoon b) press and release the T button c) the display will show ­ : ­ ­ d) press and release the h/min button till the correct hour is shown (hold it down to "fast forward" the display) e) press and release the T button ­ the minutes side of the display will flash f) press and release the h/min button till the correct minute is shown g) leave the controls alone for 5 seconds ­ the display will settle at the correct time , If you don't press the h/min button within 5 seconds, the coffee maker will revert to "normal", and show the time. Press and release the T button, and start again. [. . . ] It's on the rating plate (usually underneath the product). The product isn't user-serviceable. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. If it's still not working, consult your retailer. [. . . ]