User manual RUSSELL HOBBS MONTANA CORDLESS KETTLE

[. . . ] Grip the top of the filter and pull it up and out of its grooves. Brush it with a soft brush, under a running tap Rinse the kettle, in case any scale particles have fallen inside. To replace, simply slide the filter back down the grooves on either side of the spout, inside the kettle. Close the lid. connection to the electricity supply This product must be earthed. [. . . ] You may use a little household detergent, but if you do, rinse well to avoid tainting the water. Don't put the kettle or power base in any liquid. Don't use harsh or abrasive cleaners or solvents. important safeguards Follow basic safety precautions, including: 1. Don't put the kettle, power base, cable, or plug in any liquid; don't use the kettle in a bathroom, near water, or outdoors. 2. This kettle must only be used by or under the direct supervision of a responsible adult. 4. Don't open the lid while the water is heating. 5. Take care when pouring -- pour slowly, and don't over-tilt the kettle. 6. The scald hazard lasts long after boiling. Keep the kettle, power base, and cable away from the edges of worktops and out of reach of children. 7. Route the cable so it doesn't overhang and can't be caught accidentally or tripped over. Wind excess cable beneath the power base. 8. Unplug the power base when not in use, before repositioning and before cleaning. Let the kettle cool down fully before cleaning and storing away. 9. Check the lid is properly closed before switching the kettle on, otherwise it may not switch off. 10. Check the kettle is properly located on the power base before switching on. 11. Don't switch on unless the kettle is filled at least to the min mark. 12. Don't fill past the max mark, or it may spit boiling water. 13. Remove the kettle from its power base before filling or pouring. 14. Keep the kettle, power base, cable, and plug away from sources of heat. 15. Don't use the kettle for any purpose other than heating water. 16. Use the kettle only with the power base supplied (and vice versa). 17. Don't use the kettle if it's damaged or malfunctions. If the power base or cable is damaged, replace the power base, in order to avoid hazard. filling warning Keep clear, steam will escape from the lid. [. . . ] If this happens, let the kettle dry before use -- sit it somewhere warm for 12 hours. When you lift the kettle, you may see moisture on the power base. Don't worry -- it's the steam used to switch off automatically, which then condenses and escapes via vents under the kettle. You may see some discolouration on the floor of the kettle. [. . . ]