User manual RUSSELL HOBBS SAVANNAH KETTLE

[. . . ] 8 Route the cable so it doesn't overhang, and can't be tripped over or caught. 9 Unplug the stand when not in use, before moving and before cleaning. Let the kettle cool down before cleaning and storing away. 10 Check the lid is fully closed before switching the kettle on, or it may not switch off. [. . . ] The lights on either side of the kettle and in the water level window will glow, and the kettle will heat up. 16 When it boils, it'll switch itself off, and the lights will go out. 17 To switch off manually, move the switch to 0. 11 12 13 14 15 boiling general 18 Remove the kettle from the stand before pouring. 19 To avoid the risk of splashing, pour slowly and don't over-tilt the kettle. 20 Don't tilt the kettle backwards ­ water might get on to the control area. If this happens, let the kettle dry before use ­ sit it somewhere warm for 12 hours. 21 Don't worry if you see moisture on the stand ­ it's the steam used to switch off automatically, which then condenses and escapes via vents under the kettle. 22 You may see some discolouration on the floor of the kettle. Again, don't worry ­ it's due to the bonding of the element to the kettle floor. using with insufficient water 23 This will shorten the life of the element. 24 A boil-dry cut-out will switch the kettle off. 25 To reset the boil-dry cut-out, remove the kettle from the stand, and sit it on the work surface till it's cold. 26 Don't fill the kettle till it's cold, or it may spit. 27 Check that the switch is off ­ move the switch to 0. 28 Unplug the stand, and let the kettle cool down before cleaning. 29 Wipe the kettle, inside and out, with a damp cloth. You may use a little household detergent, but if you do, rinse well to avoid tainting the water. 32 Don't put the kettle or stand in liquid. 33 Don't use harsh or abrasive cleaning agents or solvents. care and maintenance descale regularly ­ even in soft water areas 34 Limescale may be white, coloured, even rusty-looking, but it's normally visible. 35 Phosphate scale isn't generally visible, but it's there, even in soft water areas. 36 All scale causes overheating, which reduces the life of the element, and may trigger the boil-dry cut-out. 37 So, even with soft water, descale regularly, to help keep your kettle in working order. [. . . ] It's on the rating plate (usually underneath the product). The product isn't user-serviceable. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. If it's still not working, consult your retailer. [. . . ]