User manual RUSSELL HOBBS VELOCITY 25610-56

[. . . ] Read the instructions, keep them safe, pass them on if you pass the appliance on. Follow basic safety precautions, including: This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children must not use or play with the appliance. Keep the appliance and cable out of reach of children. [. . . ] Note that during the brewing cycle, ALL of water you put in the reservoir will be used. Open the filter compartment and place a #4 paper filter into the filter holder. For each large cup, add 6g of ground filter coffee to the filter. The amount of ground coffee you add will depend on how much water you have added to the reservoir. For example, if you have filled the reservoir to the 6 cups mark, add 6 measures of ground coffee. Select the desired coffee strength using the bb button. Slowing down the rate that water passes through the pre-ground coffee. After a short time, the light around the button will flash while the coffee is brewing. Once the coffee is brewed, the light will stop flashing and remain lit. Once brewed, the hotplate will keep the coffee warm for 40 minutes after brewing. The keep warm mode is indicated by the light around the + button coming on. After 40 minutes, the light will go out. uSING THE TIMER Note: Make sure the clock is set to the correct time. Prepare the coffee maker according to which mode you are using but do not press the + button to start brewing. The button will flash and the Y icon will flash on the display. Within 10 seconds of pressing the Y button, use the hr and min buttons to enter the time you want your coffee maker to start brewing. If a time has previously been programmed, it will flash on the display otherwise the display will show the default setting of 8:00. 10 seconds after you have finished entering the time, the Y button will stop flashing and remain lit. The Y icon on the display will also stop flashing and remain lit. Your coffee maker is now programmed to brew at the time you have entered. If you want to check the program time press the Y button. The programmed time will show for 3 seconds and then return to the time of day. [. . . ] The automatic self clean process will start and will continue for about 45 minutes. After the process has finished, your coffee maker will switch off. Products returned under guarantee with faults due to scale will be subject to a repair charge. CLEANING FREQUENCY Daily - Remove any used coffee grounds and filter papers as required. [. . . ]