User manual RUSSOUND 862P PLASMA EYE

[. . . ] PRODUCT OVERVIEW The SaphIR 862P Plasma Eye receives IR signals from a handheld IR remote control and relays these signals to the audio/video equipment for operation from another room. Mounts through a circular hole with a diameter of 0. 5", requires a minimum clearance of 2. 0" behind the face of the mounting surface, and will mount in a panel with a maximum thickness of 1. 75". SaphIR 862P Plasma Eye Mini Infrared Receiver Plasma and CFL Friendly Instruction Manual FEATURES · Plasma-friendly - can be placed near plasma TVs and displays. · CFL-friendly - allows installations in areas with compact fluorescent lighting. [. . . ] If necessary, use one or both of the included washers for a more secure installation into soft or thin materials. WIRE CONNECTIONS Direct Connection from 862P Plasma Eye to Connecting Block Connect the SaphIR 862P Plasma Eye to the 857 or equivalent connecting block. Connect GND (GROUND), IR (SIGNAL) and Voltage (+12VDC ) to connector on the 857. CONNECT TO 846C OR 1201A POWER SUPPLY 12 VDC +12VDC STATUS 857 INFRARED CONNECTING BLOCK IR CONFIRM 1 IR RECEIVER IN IR COMMON IN Mounting Surface Front Max thickness 1. 75" Barrel Mounting Surface Rear Washer +12VDC 5 GND STATUS SIGNAL DESIGNED IN USA MADE IN CHINA 857 CONNECTING BLOCK SIGNAL (White) +12VDC (Black) GND (Black) Panel Face Min. clearance 2. 0" Nut EMITTER PORTS Bezel Plasma Filter +12VDC POWER 2 EMITTERS 3 4 6 WIRE CONNECTIONS Extended Leads from 862P Plasma Eye to Terminal Strip to Connecting Block The extended connection between the IR receiver and the connecting block should be made with twisted-pair wiring (i. e. , CAT-5e cable). It may be necessary to use shielded twisted-pair wiring if the wiring is exposed to interference from power wiring centers or from broadcast signals (FM, TV, etc. ) located nearby. The installer should determine the cable type needed to suit the local conditions of the installation. A terminal strip is included for extending the leads. PACKAGE INCLUDES: SaphIR 862P Plasma Eye IR Receiver (1) Colored Bezel (3: white, black, brass) Terminal Strip (1) Screws (2) Two-way Mounting Tape (1) Washers (2) 862P Eye SIGNAL 862P Plasma Eye GND (Black) CAT-5e BL 857 SIGNAL SPECIFICATIONS Receive Frequency: 36kHz to 58kHz Transmit Frequency: 40kHz and 56kHz Range: On Axis ­ 55ft to 80ft 30º Off Axis ­ 30ft to 55ft Power: 12VDC 31mA max. Dimensions: 0. 46" Diameter x 2. 03"D Mounting Cord Length: 6. 5 ft. +12VDC GND GR/GRW +12VDC BR/BRW OR/ORW BLW GND GND GND SIGNAL (White) +12VDC (Black) Blue/White Open Blue Blue/White Terminal Strip Green Green/White Brown Brown/White Orange Pair Open LIMITED WARRANTY Drain Orange Pair and Blue/White to GND on 857 CAT-5e cable Green Green/White Brown Brown/White +12VDC STATUS +12VDC IR RECEIVER IN POWER IR COMMON IN +12VDC GND STATUS Orange Orange/White Blue SIGNAL DESIGNED IN USA MADE IN CHINA The Russound® SaphIR 862P Plasma Eye is fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. During this period Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner's expense and with prior written permission. Accidental damage and shipping damage are not considered defects under the terms of the warranty. Russound assumes no responsibility for defects resulting from abuse or servicing performed by an agency or person not specifically authorized in writing by Russound. Damage to or destruction of components due to improper use voids the warranty. [. . . ] Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product. 857 CONNECTING BLOCK Russound offers both CAT-5e cable (AWCAT5) and shielded twisted-pair cable (AW2260AB) which are suitable for IR installations. Contact Russound for ordering information. 857 INFRARED CONNECTING BLOCK IR CONFIRM 1 2 EMITTERS 3 4 5 6 5 Forbes Rd. Newmarket, NH 03857, USA Tel 603. 659. 5170 · Fax 603. 659. 5388 e-mail: tech@russound. com Rev. [. . . ]