User manual RUSSOUND CAS-RC

[. . . ] The remote sends IR codes from its library to the selected device, starting with the most popular code first. If the device does not respond, press CH+. To search for other device codes, repeat steps 1-5. CHECKING THE CODES If you have set up the remote using the procedure in "Searching for Your Code, " you may need to find out which five-digit code is operating your equipment. For example, to find out which code is assigned to your TV: 1. [. . . ] Test the unit by pressing Power and any mode key. If the batteries are inserted correctly, the LED will blink once. USING LEARNING The CAS-RC includes a Learning feature so you can add functions that are unique to your home entertainment devices (e. g. , VCR Tracking Up or Down). · The original remote controls must be in working order for learning to work properly. · Learned keys are mode specific, so each one can store a unique function for each mode. · Do not use the following keys for learning: Device Keys, SET, BACK, or Record. · Learning capacity is approximately 40 to 100 keys, depending on the code being learned. · Certain device codes are not learnable including multi-frequency types, some high frequency ones, and other unusual formats. · For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights. · Have the original remote controls handy before programming learning. Programming a learned key Note: If more than 15 seconds pass between key presses, the remote exits programming. Press and hold SET until LED flashes twice. Press a device key once (e. g. , S1, S2, S3, S4) to assign a mode for learning. Place the CAS-RC head-to-head (about 2" apart) from your original remote control. Also locate the key (on original remote control) that will serve as the teaching function. On the CAS-RC, press a key where the learned function will be stored. On the original remote, press and hold the the key to be learned. The CAS-RC LED will turn off. Continue holding the key on the original remote until the CAS-RC LED blinks twice. Note: If the LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture occurs. If the function is still not captured, press and hold SET to exit programming. Review the learning precautions listed above, or the Troubleshooting tips below, before beginning again at step 1. To program another key for the same source, repeat steps 5-6. To program another device, repeat steps 1-6. [. . . ] Press and hold SET until the red LED blinks twice, then release. Enter 9-9-1, then the device group number (see below). 0 Cable (Cable Converters, Video Accessories, Satellite Receivers) 1 TV (TVs) 2 VCR (VCRs, DVD players) 3 Audio (Audio Amplifiers, Audio Amp/Tuners, CD players) Raise or lower the sound level. Press MUTE to turn the sound off or on. Move the cursor in the menu screens. Press OK to choose the high-lighted menu option. [. . . ]