User manual RUSSOUND SMART SELECT VOLUME CONTROL

[. . . ] Russound Ultra-MatchTM Volume Controls eliminate the need for an impedance-matching speaker selector. With a few simple calculations and jumper settings, your SSVC system can be configured to connect up to 16 pairs of speakers to a single amplifier. Smart SelectTM Volume Control Instruction Manual 2 SYSTEM IMPEDANCE = the surface of a metal junction box during installation or removal. The junction box must also have a depth of at least 3 1/8". 5) Since you have determined the system impedance you can now calculate the jumper setting needed to protect your amplifier. EXAMPLE: JUMPER SETTING = AMPLIFIER'S MIN. [. . . ] 7) Once all connections are made, install the SSVC in the junction box or plaster ring. Insert carefully to avoid excessive strain on the connector. Taking the time to feed the excess wire out the back of the junction box will help you with the final assembly. If a junction box will be used, Russound recommends you use plastic junction boxes, if possible. This is to help ensure that the volume control does not short against 5 OPERATION INSTRUCTIONS 1) Make sure the amplifier or receiver is turned Off and it's volume set to minimum. 2) Connect 12 Volt power to the Smart SelectTM System (see Figure 2) NOTE: The 12 Volt power supply (Russound part No. 1201A) must be connected through the Russound Smart SelectTM Power Interrupter Module (Figure 2). 3) The status indicator light should be illuminated red on all volume controls connected. This means that the volume control is currently in Mute mode, and that the speakers are disabled. 4) Press the function control button once. The status indicator should now blink 3 times and then turn solid green. This means that the SSVC is now in Active mode, and that the speakers are enabled. 5) Repeat step 4 on all remaining volume controls. 6) Set the Smart SelectTM volume to maximum (fully clockwise). 7) Turn On the amplifier or receiver and select a music source, such as tuner or CD player. 8) Slowly turn up the amplifier or receiver volume and set it to a comfortable (not maximum) listening level. Be careful not to overdrive your amplifier. If the sound becomes muddy or distorted, you have LIMITED WARRANTY The Russound SSVC is fully guaranteed for Two (2) years from the date of purchase against all defects in materials and workmanship. During this period Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russound at the owner's expense and with prior written permission. [. . . ] 2) Press and hold the function control button until the status indicator blinks amber. 3) All connected SSVCs will now be in Active mode. To turn Off Smart SelectTM System 1) On any SSVC, press the function control button until the status indicator light is red. 2) Press and hold the function control button until the status indicator blinks amber, and then turns red. [. . . ]