User manual RYOBI 120R

[. . . ] If you use your saw properly and only for what it is intended, you will enjoy years of safe, reliable service. Thank you again for buying Ryobi tools. SAVE THIS MANUAL FOR FUTURE REFERENCE. RULES FOR SAFE OPERATION The purpose of safety rules is to attract your attention to possible dangers. The safety symbols and the explanations with them, require your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. [. . . ] Parabolic Wheel 10 x 15 mm Grit 150 1pce Page 3 15. Grinding Wheel 20 x 3 mm Grit 150 1pce 16. Grinding Wheel 10 x 3. 2 mm Grit 150 1pce 17. Twist Drill Bit 2. 4 mm 1pce (It is mounted into the flexible shaft) 22. Mandrel for Cut Off Wheel 1. 8 mm screw 1pce 25. Dressing Stone SI Carbide 25. 4 x 9. 8 mm Grit 120 1pce 27. Grinding Wheel 9. 8 x 10 mm Grit 150 1pce 28. Parabolic Wheel 10 x 19 mm Grit 150 1pce 29. Grinding Wheel 5. 4 x 15 mm Grit 150 1pce Phillips Screw Blade Pointer Adjustment Screw Square Table Degree Scale Table Lock Knob Fig. 2 On/Off and Variable Speed Switch Fig. 3 Page 4 Adaptor Guard Blade Pin Cap Screw Blade Slots Arm Blade Tension Knob Loosen Tighten Pin Recesses Blade Blade Positioned Positioned for side cutting for front cutting Upper Inner Blade Holder Table Tilted for picture clarity Lower Inner Blade Holder Fig. It allows your scroll saw to cut like a band saw. In order to cut, and avoid uncontrollable lifting of the workpiece, the teeth of the blade used on the scroll saw should always point downwards when installed. Install the blade while inserting one end of the blade through the access hole in the table and hook the blade pin in the pin recess in the lower blade holder. Slide the top blade pin into the pin recess of the inner upper blade holder. You may need to press down lightly on the upper blade holder to install the blade. Carefully tighten the blade by rotating the blade tension knob clockwise just until you feel the slack in the blade removed. Double check to see that the pins are properly located in the blade holder. Then turn the blade tension knob ONE full turn clockwise. This amount of blade pressure is required for most cutting operations and blades. Loosen the table lock knob(7), and move the table until it is approximately perpendicular, or at a right angle to the blade(a). Place a small square(c) on the table next to the blade as shown to check if the table is 90° to the blade. If adjustment is needed, raise or lower the table until table is approximately 90° to the blade and securely tighten the table lock knob. [. . . ] Clamp or otherwise secure the work to prevent it from shifting. Hold the tool tightly and keep it a safe distance from users. Always point the bit away from your body. Ensure that ventilation openings are kept clear when working in dust conditions. [. . . ]