User manual RYOBI 130R-SERIALS-203008501-THRU

[. . . ] This operator's manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. I. TABLE OF CONTENTS Rules for Safe Operation . 8 II. PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. [. . . ] This unit plug will fit into a polarized extension cord only one way. If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into a polarized wall outlet only one way. If the plug does not fit fully into the wall outlet, reverse the plug. If the plug still does not fit, contact a qualified electrician to install the proper wall outlet. Do not change the unit plug, extension cord receptacle, or extension cord plug in any way. 1. Use the cord hook when you connect the extension cord to the power cord to prevent disconnection (Fig. Use only an outdoor-approved extension cord as specified in the Rules for Safe Operation section. Secure the extension cord to motor housing as shown (Fig. · The right arm is slightly bent, and the hand is holding the housing grip. · The left arm is straight, and the hand is holding the D-handle. · The cutting attachment is parallel to the ground and easily contacts the vegetation to be cut without the operator having to bend over. Each time the head is bumped, about 1 inch (25. 4 mm. ) of trimming line is released. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released. For best results, tap the Bump Head on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter. NOTE: Do not rest the Bump Head on the ground. CAUTION: Do not remove or alter the line cutting blade assembly. Excessive line length will make the motor overheat. [. . . ] 0. 080 in (2. 03 mm. ) Cutting Path Diameter . (38. 1 cm) EDGER ADD-ON Unit Weight (Add-On only) . 1. 23:1 SWEEPER/BLOWER ADD-ON Unit Weight (Add-On only) . up to 100 MPH 18 NOTES 19 LIMITED TWO-YEAR WARRANTY RYOBI OUTDOOR PRODUCTS warrants each new RYOBI Product for two (2) years according to the following terms. [. . . ]