User manual RYOBI 182823 RYOBY-TB3000

[. . . ] Owner/Operator Manual 2-Cycle Trimmer · · · · Safety Assembly Operation Maintenance Models TB3000 ­ 25cc Straight Shaft ©2000 MTD SOUTHWEST INC FORM 182823 (12/00) (10209 rev. A) Printed in U. S. A. Introduction THANK YOU Thank you for buying this quality product. This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. [. . . ] Avoid creating a source of ignition for spilt fuel. Do not start the engine until fuel vapors dissipate. NOTE: Dispose of the old fuel/oil mix in accordance to Federal, State, and Local regulations. 10 Section 5 Operation Start/ On (I) Avoid accidental starting. Be in the starting position whenever pulling the starting rope. To avoid serious personal injury, the operator and unit must be in a stable position while starting. STARTING INSTRUCTIONS Stop/ Off (O) Fig. 5-1 On/Off Stop Control Choke Lever Run (B) Start (A) Primer Bulb 1. Put the On/Off Stop Control in the START (I) position (Fig. Fully press and release primer bulb slowly 5 to 7 times. Fuel should be felt and visible in the bulb (Fig. If fuel hasn't entered the bulb, press three more times, or until it does. Place the choke lever in the START (A) position (Fig. With the unit on the ground, squeeze the throttle control and hold. Continue pulling until the engine sounds as though it wants to run (normally 2 to 5 pulls). NOTE: Squeeze the throttle control until the engine has started and warmed up. Place the choke lever in the RUN (B) position (Fig. Pull starter rope briskly 1 to 3 times to start the engine (Fig. If the engine does not start, repeat steps 4 through 7. NOTE: If the engine floods while trying to start, place the choke lever in the RUN (B) position. The engine should start within three (3) to eight (8) pulls. Squeeze the throttle control to warm up engine for 5 to 10 seconds. Place the choke lever in the RUN (B) position (Fig. NOTE: Choking is unnecessary when starting a warm engine. Put the On/Off Stop Control in the START (I) position (Fig. [. . . ] 18 inches (44. 0 cm) 20 Notes 21 MANUFACTURER'S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD SOUTHWEST INC ("MTD") with respect with new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. This limited warranty shall only apply if this product has been operated and maintained in accordance with the Operator's Manual furnished with the product, and has not been subject to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of other peril or natural disaster. Damage resulting from the installation or use of any accessory or attachment not approved by MTD for use with the product(s) covered by this manual will void your warranty as to any resulting damage. [. . . ]