User manual RYOBI 2075R

[. . . ] MODEL 2075r GAS TRIMMER OPERATOR'S MANUAL FOR QUESTIONS, CALL 1-800-345-8746 in U. S. or 1-800-265-6778 in CANADA IMPORTANT MANUAL DO NOT THROW AWAY INTRODUCTION THANK YOU Thank you for purchasing this quality product. This modern outdoor power tool is designed to provide many hours of useful service. You will find it to be a great labor-saving device. [. . . ] While firmly holding the upper boom, pull the lower boom straight out of the Click-Link (Fig. Click-Link Release Button Upper Boom Release Button Fig. Tighten the knob securely clockwise before using the unit (Fig. 8 If your unit is not assembled, or you have more than one attachment, use the following instructions: Installing the Lower (Attachment) Boom 1. Remove the hanger from the lower (attachment) boom. Hold the release button down while pushing the lower (attachment) boom into the Click-Link (Fig. 10 Guide Recess Knob 180° Edging Hole Lower Boom Click-Link Primary Hole 2. BASIC TRIMMING OR USING OTHER RYOBI ATTACHMENTS - Locate and lock the release button into the primary hole in the Click-Link (Fig. EDGING WITH THE TRIMMING HEAD ATTACHMENT - Locate and lock the release button into the 90° edging hole or 180° edging hole in the Click-Link (Fig. CAUTION: Make sure the release button is locked in the primary hole and knob is securely tightened before operating this unit. CAUTION: All attachments are designed to be used in the primary hole unless otherwise indicated in the attachment's operator's manual. If the incorrect hole is used, it could result in injury, or damage to the unit. 10 OPERATING INSTRUCTIONS ADJUSTING TRIMMING LINE LENGTH Your unit is equipped with a cutting head that allows the operator to release more trimming line without stopping the engine. To release additional line, lightly tap the cutting head on the ground (Fig. 11) while operating the unit at high speed. NOTE: Always keep the trimming line fully extended. Line release becomes more difficult as cutting line becomes shorter. DECORATIVE TRIMMING Decorative trimming is accomplished by removing all vegetation around trees, posts, fences, etc. Rotate the entire unit so that the cutting head is at a 30° angle to the ground (Fig. 11 Each time the head is bumped, about 1 inch (25. 4 mm) of trimming line is released. A blade in the string guard will cut the line to the proper length if excess line is released. For best results, tap the head on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. CAUTION: Do not remove or alter the line cutting blade assembly. [. . . ] The RYOBI Product including any defective part must be returned to an authorized service dealer within the warranty period. The expense of delivering the RYOBI Product to the dealer for warranty work and the expense of returning it back to the owner after repair or replacement will be paid for by the owner. RYOBI's responsibility in respect to claims is limited to making the required repairs or replacements and no claim of breach of warranty shall be cause for cancellation or rescission of the contract of sale of any RYOBI Product. Proof of purchase will be required by the dealer to substantiate any warranty claim. [. . . ]