User manual RYOBI 216.51716

[. . . ] 6 26 27 28 6 36 3 35 13 34 28 26 27 Fig. 8 22 41 40 37 39 21 35 23 Fig. 10 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications. English GENERAL POWER TOOL SAfETy WARNINGS WARNING Read all safety warnings and all instructions. [. . . ] Liquid ejected from the battery may cause irritation or burns. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and 2 ASSEMBLy AUXILIARy HANDLE ASSEMBLy See Figure 2. An auxiliary handle is packed with the drill for ease of operation and to help prevent loss of control. The handle can be mounted on the opposite side for left or right hand use. Insert handle screw into hole located above trigger switch and seat hex head into hole. Slide handle collar onto screw, seat hex end of collar into hex hole. Hex hole for depth stop rod should be on top of collar. Slide depth stop rod into hex shaped hole on top of collar. English ASSEMBLy Slide depth guide clamp into notch in collar. NOTE: When properly installed, the teeth on the depth stop rod should be aligned with the teeth indicator on the depth stop rod clamp. Thread auxiliary handle onto screw and secure tightly. NOTE: Be sure the auxiliary handle is securely tightened against the depth stop rod clamp. WARNING Battery tools are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. To turn the drill ON, depress the trigger switch. To turn it Off, release the trigger switch. VARIABLE SPEED The variable speed trigger switch delivers higher speed and torque with increased trigger pressure and lower speed with decreased trigger pressure. NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function. ROTATION SELECTOR held in normal operating position, the rotation selector should be positioned to the left of the trigger switch for forward drilling. The drilling direction is reversed when the selector is to the right of the trigger switch. Setting the trigger switch in the Off (center lock) position helps reduce the possibility of accidental starting when not in use. CAUTION: To prevent gear damage, always allow the chuck to come to a complete stop before changing the direction of rotation. [. . . ] Do not use a wrench to tighten or loosen the chuck jaws. DRILLING Check the rotation selector for the correct setting (forward or reverse). Secure the material to be drilled in a vise or with clamps to keep it from turning as the drill bit rotates. Hold the drill firmly and place the bit at the point to be drilled. [. . . ]