User manual RYOBI 2400W ABRASIVE CUTOFF SAW 355MM ECO2437

[. . . ] ECO2437 355mm(14") CUT-OFF SAW OWNER'S OPERATION MANUAL 17 18 13 2 1 12 11 10 5 9 6 7 8 3 4 22 Fig. 1 23 15 14 16 19 3 11 22 20 10 21 8 Fig. 2 24 25 26 27 2 28 29 30 Fig. 3 3 32 31 b Fig. 4 a Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 33 34 Fig. 14 ENGLISH RULES FOR SAFE OPERATION USE SAFETY GLASSES Use face or dust mask if the cutting operation is dusty. Also use ear protection to reduce the risk of induced hearing loss. Safe operation of this power tool requires that you read and understand this operator's manual and all labels affixed to the tool. Safety is a combination of common sense, staying alert, and knowing how your cut-off machine works. [. . . ] Clean outer flange, then align flats with flats on wheel arbor and slide it onto arbor until it is flushed against wheel. Place recessed side of outer washer against arbor, then insert wheel bolt into threaded end of wheel arbor. Start threads and turn bolt clockwise to snugly tighten. Pull the spindle lock button and rotate bolt until spindle being locked. Using the wrench provided, securely tighten wheel bolt. This will secure the fence in place at desired angle. ADJUSTING WIDTH OF CUT (Fig. 5-6) Unplug your cut-off machine. WARNING: Failure to unplug cut-off machine could result in accidental starting causing possible serious personal injury. The default space between the vice and the fence is 0 mm min. By following the below adjustment procedures, it is possible to increase that distance so that the vice is between 35 mm and 205 mm or 70 mm and 240 mm from the fence. WARNING: Bevel cutting angle is not suitable for the above 2 suggested width of cuts. To increase the width of cut of your cut-off machine, loosen and remove the fence quick lock and washer. The use the wrench supplied to loosen and remove the fence bolt and washers to secure fence to machine base. Reposition the curved slot of the fence with the threaded hole (b) at the back of the machine base. Install a fence quick lock through a flat washer into machine base. Do not tighten fence quick lock bolt securely. Align remaining fence bolt hole with the middle threaded hole (a) of the machine base. Install fence bolt through lock washer and flat washer into machine base. Check and adjust fence to 0o cutting angle. Securely tighten fence quick lock and fence bolts. This position is good for cutting thin and wide pieces of stock, such as flat or angled stock. To increase the height of cut of your cut-off machine, follow the above procedure except place the rear fence bolt in the middle threaded hole (a) and the front fence bolt in the front threaded hole. Check and adjust fence to desired cutting angle. Using the wrench provided, securely tighten fence quick lock en fence bolts. [. . . ] Failure to heed this warning could result in serious personal injury. MAINTENANCE WARNING: To ensure safety and reliability, all repairs (with the exception of the externally accessible brushes ) should be performed by a Ryobi Authorized Service Centre. BRUSH REPLACEMENT (Fig. 14) Your cut-off machine has externally accessible brush assemblies that should be periodically checked for wear. Proceed as follows when replacement is required: Unplug your cut-off machine. 8 ENGLISH TROUBLESHOOTING PROBLEM Machine does not start CAUSE 1. Switch is damaged or burned out. SOLUTION 1. [. . . ]