User manual RYOBI 710R-SERIALS-301112306-AND-GREATER

[. . . ] Subject to technical modifications. English GENERAL POWER TOOL SAFETY WARNINGS 3. Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. SAFETY PRECAUTIONS IMPORTANT To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the supply voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. When using cable drums, run all the cable off the drum. 2 IMPORTANT It is imperative to follow all national safety regulations concerning installation, operation and maintenance of the tool. If incorrectly fitted, chisel bits and drill bits may be flung out of the tool accidentally and cause serious injury. Before you start using your hammer drill, always check that the chisel or drill bit is properly locked in the chuck. Examine the chuck regularly for signs of wear or English damage. Always press the hammer drill against the work surface (wall, ceiling, etc. ) before you start it. When you are finished, unplug the hammer drill from the power supply and remove the chisel or drill bit. Always disconnect the hammer drill from the power supply before you change the chisel or drill bit. Wear safety goggles to protect your eyes from flying particles and splinters. Wear a helmet and put up partition walls in your work place! Wear work gloves to protect fingers from bruising and grazing. Vibrations can injure the hand-arm system. [. . . ] Position the handle as required then lock securely by rotating the handle clockwise until it is tight. Loosen wing bolt to adjust the depth stop. The depth of the hole drilled will be equal to the distance between the end of the drill bit and the front end of the depth stop. SPECIFICATIONS Voltage Power consumption No-load speed (Drill mode) Hammer speed (Blows per minute) Impact energy Tool attachment Weight Maximum drilling capacity steel concrete/stone 13 mm 24 mm 240 V 710 W 0-1100 min-1 0-4000 min-1 2. 0 J SDS-plus 3. 0 kg 50 Hz OPERATION BEFORE STARTING TO USE YOUR HAMMER DRILL Examine the place where the tool is to be used for hidden electrical cables, gas, and water pipes using a pipe finding device. Before you plug in your tool, make sure that the supply voltage used corresponds to that indicated on the rating plate. 3 English MODE SELECTOR See Figure 6. [. . . ]