User manual RYOBI 710W ROTARY HAMMER DRILL ERH710RG

[. . . ] ERH710RG ROTARY HAMMER DRILL OWNER'S OPERATING MANUAL DESCRIPTION 1. Locking collar Variable switch with reverse action Lock-on button Auxiliary handle Depth stop 6. Drill mode 1 2 3 5 6 7 4 Fig. 6 Important! It is essential that you read the instructions in this manual before operating this machine. [. . . ] Use of the power tool for operations different from intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. SAFETY PRECAUTIONS IMPORTANT To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the supply voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. When using cable drums, run all the cable off the drum. When using the electric hammer drill outdoors, connect it to an outdoor-grade extension cable type H07RN-F 2G, 1. 0 mm and rain-water-protected plugs in proper working order. Make sure of your footing when drilling freehand. Before drilling, use a line detector to locate concealed electric, water or gas lines in walls. Avoid touching live components or conductors. Wear goggles and use a dust mask on jobs generating dust. Exposure to noise can cause hearing loss. Do not use your hammer drill near flammable liquids or gases. Always pull the plug out of the socket before cleaning your tool or changing accessories. Keep the power cable in good condition. Make sure your workplace is safe. SPECIAL SAFETY RULES Wear ear protectors. Exposure to noise can cause hearing loss. Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. If operation is dusty, also wear a dust mask. Hold power tool by insulated gripping surfaces when performing an operation where the cutting accessory may contact hidden wiring or its own cord. [. . . ] Check that it has locked by pulling on it. REMOVING THE BIT FROM THE SDS-PLUS SYSTEM Pull back the locking collar and remove the bit. CHUCK ADAPTOR (IF INCLUDED) For drilling work in metal, wood and plastic with drill bits that have non SDS plus shaft, the drill adaptor is available. SWITCHING ON/OFF Speed control The speed of the drill may be varied by increasing the pressure exerted on the trigger. [. . . ]