User manual RYOBI 720R1-SERIALS102055901-THRU-203096320

[. . . ] Do not use any adaptor plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce the risk of electric shock. b) Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. [. . . ] A moment of inattention while operating power tools may result in a serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. Move the sander evenly over the entire work area. (Fig. 8) The weight of the sander alone is sufficient for normal use. Any excess pressure will retard the sanding action, giving an uneven finish and cause extra wear to both tool and sanding paper. Never allow sander to stay in one place too long, or excessive material will be removed. Always start sander before applying it to the work piece. The sander should never be turned off while resting on the work piece. Lift the tool from workpiece and then turn it off. Do not use the tool without sanding paper, or the rubber pad will be damaged. Take care that your hand does not cover the vents and make sure oil or water does not come into contact with the motor. ¡ö ¡ö WARNING: This sander is designed for light consumer use. It is NOT designed for trade or industrial use and is not covered by the guarantee for use in these applications. SPECIFICATIONS Power input: No load speed: Sanding pad size: Net weight: 200 W 5, 000-10, 000 min 90 x 184 mm 1. 75 kg -1 OPERATION It is recommended that the tool always be supplied via a residual current device with a rated residual current of 30mA or less. FITTING THE SANDPAPER WARNING: Never cover the air vents. They must be open at all times for proper motor cooling. DUST COLLECTION BOX ¡ö SPECIFIC SAFETY WARNINGS ¡ö ¡ö ¡ö ¡ö ¡ö Use clamps or other practical way to secure and support the workpiece to a stable platform. [. . . ] Pull out both the front and rear clamping levers to the open position and insert the ends of the sandpaper under both clamps. (Fig. 3) Ensure that the sandpaper is taut on the base. Push both clamps in to the closed position to secure the sandpaper. (Fig. 4) ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö Your sander is equipped with a dust collection box. [. . . ]